Important note about SSL VPN compatibility for 20.0 MR1 with EoL SFOS versions and UTM9 OS. Learn more in the release notes.

Thread Info
  • State Suggested Answer
  • +1 person also asked this people also asked this
  • Locked Locked
  • Replies 5 replies
  • Answers 1 answer
  • Subscribers 42 subscribers
  • Views 12568 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

VLAN Trunk tagging or not?

Bernhard Lang

Hi,

i have a new XG125 in my Office.

I want to seperate my Networks with VLANs:

VLAN-ID1 = Admin / System-Management

VLAN-ID2 = User

...

Config on Switch:

Port 1 (to XG):

* VLAN-ID 1 tagged

* VLAN-ID 2 tagged

 

Config on XG:
Port 1 (to Switch):

* Zone LAN

* IP in VLAN 1

Port 1.2

* Zone LAN

* IP in VLAN 2

Routes to the VLANs over the Interfaces, no Gateways

FW-Rule: LAN2LAN allow, all Networks

 

But from my Clients in VLAN2 i can't access the XG, either the VLAN2-IP nor the VLAN1-IP.

When i untag the Port on my Switch, i can Access the XG in one VLAN, but not in the other?

 

What am i doing wrong? Thanks for any help!

 

Regards,

Bernhard



This thread was automatically locked due to age.
Parents Reply Children
  • 0 in reply to Bernhard Lang

    In networks you add a VLAN. The new VLAN must have a seperate IP address range as to the physical port. It will be identified a 1.5 if you called it VLAN 5.

    The physical port cannot be tagged in an XG.

    Ian

    XG115W - v20.0.2 MR-2 - Home

    XG on VM 8 - v21 GA

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to rfcat_vk

    Hi and thanks.

    Also this is not what i wanted, i used this hint ;-)

    I used now VLAN1 untagged and as Port-VLAN-ID on the Switch. So all untagged Frames are assigned to VLAN1 on the physical Port of the XG. And when the XG sents an untagged Frame, the Switch assign this Frame to VLAN1.

    So I can use the VLAN ID 1 as i wanted :)

    All other VLANs are tagged on the Switch on the Trunk-Port and I configured a seperate VLAN-Interface on the XG for each other VLAN.

  • 0 in reply to Bernhard Lang

    @Bernhard Lang

    Hi,

    Did you put VLAN1 IP address(GW) on physical port. And than every GW address from every vlan on subinterface.

    For example :

    Por1 - IP 10.1.1.1/24

    Port1.10 - IP 10.1.1.11/24

    Port1.20 - IP 10.1.1.21/24

    And on switch every host in Vlan 1 should have 10.1.1.0/24 address.

    This should work?

    Also Can I enable DCHP on physical port(VLAN 1)? Or it would not work because of subinterfaces?

Unfiltered HTML