Configuring VPN Remote Access for the first time on your Sophos XG Firewall? Check out this useful Community post!
We'd love to hear about it! Click here to go to the product suggestion community
I got information from my UTM that a new firmware 9.601-5 was available. I installed it and after reboot I discover that all my NAT rules where not activated ! I had to go on each one and disable/enable them to get back the working setup :(
I did it with some of them and then reboot the UTM: again rules where not applied. Disable/enable them and evrything is OK.
For some rules I didn't apply the "automatic firewall rules" in GUI but had create myself the FW rules: those NAT rules where activated. But for NAT rules with forwarding ports to other physical hosts but *not the host himself and the VMs running on it where the UTM lies* doesn't matter which setup (manual or automatically), I have to activate "automatic FW rules" and disable/enable the rules to get them working.
No need to say that prior firmware versions didn't had this problem.
Does anyone face the same problem and confirm?
In reply to GrantAU:
I updated my UTM's and I confirm that I did not need to de/reactivate NAT rules.
However I did not test all rules to confirm it is solved at 100%.
But 24 hours later, no one complained.
In reply to SAID NIAZI:
Problem solved too from my side.