This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot open User Preferences in WebAdmin Settings after upgrade to 7.500

I've just successful upgraded my test box from 7.405 to 7.500 [:)]
At first I tried to increase the items per page in Managment -> WebAdmin Settings -> User Preferences -> Table pager options but I'm getting
"Can't use string ("0") as a HASH ref while "strict refs" in use at /PerlApp/wfe/asg/modules/asg_webadmin.pm line 48. " [:(]
Can someone else report the same issue? It was working in 7.490...

Michael

This thread was automatically locked due to age.

0 suzzyx over 15 years ago

It seems to work fine here [:)]
Cancel
Vote Up 0 Vote Down

Cancel
0 Microsaft over 15 years ago

What happens if you clear you browser cache?

Had in the past some similar.....
Cancel
Vote Up 0 Vote Down

Cancel
0 rimi over 15 years ago

Clearing the browser cache or even using IE instead Firefox doesn't help. In the meanwhile I've updated my ASG at home from 7.490 and an older vm image from 7.405 without any problems.
I guess there must be hardware problem or a corrupt installation. I will do a fresh installation next week.

Thanks,
Michael
Cancel
Vote Up 0 Vote Down

Cancel
0 rimi over 15 years ago

I've run different scenarios to re-install my test box (directly from 7.405 and also via the beta software). It's always the same: It's fine until the restore of my old setup. Then I'm getting again 'Can't use string ("0") as a HASH ref while "strict refs" in use at /PerlApp/wfe/asg/modules/asg_webadmin.pm line 48.' and it happens already in the beta versions...
tomtomtom reported already the same in the beta area: https://community.sophos.com/products/unified-threat-management/astaroorg/f/98/t/68246
Cancel
Vote Up 0 Vote Down

Cancel
0 rimi over 15 years ago in reply to rimi

Just one note: this only happens if I'm using my AD account to login to the box. Using Astaros's admin account works fine.

Michael
Cancel
Vote Up 0 Vote Down

Cancel
0 rimi over 15 years ago

7.501: the problem still persist ...
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 15 years ago

Rimi, if this only happens when you use your AD login, then please submit a bug report via a support request on your MyAstaro account.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 all4it over 14 years ago in reply to BAlfson

I can confirm the same bug on ACC 2.100 Virtual/ESX system. Also loggedin with an AD account.
Cancel
Vote Up 0 Vote Down

Cancel