This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SEC 5.2.1 and Sophos for MAC OS X Preview (9.0.3)

Decided to give the Preview of Anti-Virus for Mac OS X, version 9.0.3 a try. Chose an old MacBook (running 10.4) as guinea pig. After assigning the alternate policy updating failed with a rather vacuous Error: Could not update Sophos-Anti-Virus at .... Update failed. No indication of the nature or the error and surprisingly no indication of the update location used. 

Now, the error was not unexpected - 9.0.x requires MAC OS X 10.6 minimum but perhaps a more meaningful message could be issued. Anyway I checked the update location and found that it named ESCOSXL as source folder - obviously indicating the changed requirements (though I can't figure out what the L stands for :smileyhappy:).

Admittedly pre-10.6 versions should be rare by now (I've found two 10.5 installations still in use out of about 100). But the folder name change will affect unmanaged or occasionally off-site clients (yes, Cloud is the answer :smileywink:). I've found no reference though (I'd have expected this in the Release Notes). Even as it is Preview you should be required to discover this important information on your own.

Christian   

:43783


This thread was automatically locked due to age.
Parents

  • test12234 wrote:

    Ok but does this version include the RMS part? (remote management) .. it would be great to be able to create a custom installer with remote management capabilities and be able to embed our own update servers!


    Hi test12234,

    The feature to pre-configure stand-alone installers only applies to the unmanaged endpoints. When you are using a managed endpoint (and thus will have RMS) the endpoint will connect to the Sophos Enterprise Console and receive its update settings that way.

    You may be interested in the feature that allows your endpoints to be assigned to a group on install. See KBA 119791:

    http://www.sophos.com/en-us/support/knowledgebase/119791.aspx

    Once you've configured a copy of the MPKG with this setting, any installations will automatically receive policy according to the group assignment in the console.

    :52146

    ---

    Bob Cook (bob.cook@sophos.com) Director, Software Development

Reply

  • test12234 wrote:

    Ok but does this version include the RMS part? (remote management) .. it would be great to be able to create a custom installer with remote management capabilities and be able to embed our own update servers!


    Hi test12234,

    The feature to pre-configure stand-alone installers only applies to the unmanaged endpoints. When you are using a managed endpoint (and thus will have RMS) the endpoint will connect to the Sophos Enterprise Console and receive its update settings that way.

    You may be interested in the feature that allows your endpoints to be assigned to a group on install. See KBA 119791:

    http://www.sophos.com/en-us/support/knowledgebase/119791.aspx

    Once you've configured a copy of the MPKG with this setting, any installations will automatically receive policy according to the group assignment in the console.

    :52146

    ---

    Bob Cook (bob.cook@sophos.com) Director, Software Development

Children
No Data