Delay in Console Showing Client Status

Question

Hi All,

I have a general query in regard to the length of time it takes for the status of a client to be displayed in Enterprise Console. We are running SEC (5.2.1 R2) on a Window Server 2008 R2 Enterprise (64-bit).

When deploying Sophos Endpoint Security & Control (10.3.1.498.1) to a client PC, it sometimes take upwards of 20-30 minutes after the installation has completed for the client status to appear (i.e. restart required etc.) in Enterprise Console. As I recall this wasn't the case in previous versions of Enterprise Console we ran.

Is there a set polling interval that SEC uses when querying the status of protected clients and is this configurable?

Any input would be much appreciated, many thanks,

JP

This thread was automatically locked due to age.

isoffice · Accepted Answer

Hi Christian, Just to follow up on my previous post. I disabled the backup NIC on the Console Server, and re-protected our test PC (after manually removing SAV). Good news is, the client appeared back in the Console Server as managed and connected winthin 5 minutes!!! A colleague of mine has found an article on the Sophos site which may explain what was happening here: http://www.sophos.com/en-us/support/knowledgebase/111862.aspx I think we can safely say that the culprit has at last been found. We will give the recommendations contained in the above article a go to see if that finally rectifies our issue. Many thanks again for your input, JP :49862