This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

CR25wiNG device drive full

Cyberoam Problem does anyone know how to get around this problem

I have a CR25wiNG Cyberoam with version 10.6.6 Mr1 firmware my NBN the cr25 crashed and then went into Failsafe mode I checked and was telling me signature database full
I then tried to backdate the software to previous version to fix the signature database but this errors with no space left on device
I have tried to

1 reset device

2 flush appliance reports to no avail how can I get out of this loop

its also impossible to enter in network setup
this message is displayed
"please try after sometime . system is in initialing"

is there a way to delete the signature partition to reload

This thread was automatically locked due to age.