Greeting,
Please guide me in resolving the issue.
Current environment (Active-Passive with version 18.5 and model XG330):
- Dedicated HA Link Ports connected directly.
- For Primary Firewall HA dedicated port is 7, assigned IP is 12.28.1.254/24.
- On same port created the VLAN with subnet of 10.28.1.254/16 for internal LAN.
- Dedicated Peer HA Link is 100.200.100.254.
- Peer Administration IP for auxiliary device is 12.28.1.253.
- Port7 of both FW connected on Cisco Layer 3 SW at P3 and P8 respectively and below is configuration details at Switch.
Issue:
- Not able to access GUI of auxiliary device from Peer Administration IP 12.28.1.253.
Observation:
- Firmware upgradation completed successfully without any issue .i.e. I don’t have to upgrade the firmware on individual Appliance manually.
- If I shut port either P3 or P8 depending on which port Primary appliance connected, failover take place without any physical changes.
From the above the observation, we can say that there is no issue relates to connectivity.
- Checked at Switch that mac dress table is empty for the interface at which auxiliary device connected, refer the below screenshot for reference.
Queries:
- On Active-Passive Environment, is Auxiliary Device accessible over GUI?
- As auxiliary device is on Standby Mode, so still ARP will get complete? If yes kindly guide through process if any configuration required to change either at Firewall or Switch Level.
This thread was automatically locked due to age.
