VLAN communication

Question

This is the first time I am using the Sophos Switch. The participating products are as follows: 
 1. Sophos Switch C110-24 - 1nos 
 2. Sophos XGS87 - 2nos 
 
 VLANs - 7nos: 
 4 VLANs on XGS87A 
 3 VLANs on XGS87B 
 
 The requirement is to ensure that traffic passes through the respective FWs and only 1 VLAN (IT VLAN) should be able to communicate across all VLANs. IS this setup possible with Sophos Firewall? If yes, request for the guidance in setting it up.

Mayuresh Bhagwat · Accepted Answer

Thank you all for pitching in. I had figured out the configuration and was able to successfully deploy the switch with the desired configuration and it's working fine. Apologies for missing out on updating this thread.

PhilippRusch · Answer

For others as a learning: 
 you can define a zone which you can then add to a VLAN-interface. After that you allow access to the administrative service only to that zone:

Vivek Jagad · Answer

Hello Mayuresh Bhagwat , Thank you for reaching out to the community, for the the switch you refer the adding a VLAN here . And for Sophos XGS here . Once you have added a VLAN, and the physically connection are connected properly, please let us know the status of it and revert us if you are facing the any challenge !

VLAN communication

Top Replies