XG210 HA License swapped

Hi,

Maybe some one can help, I have an HA A/P with xg210's after the Primary got a RMA we build the new HA from the Aux. Now the wrong license is in the HA setup.

After searching i found this: https://community.sophos.com/xg-firewall/f/discussions/117909/cannot-sync-license---after-registering-the-xg-135-and-changing-the-ca-i-have-only-base-license

 

Quote:

  1. Log on XG firewall SSH terminal using admin account.
  2. Once authenticated, you will be presented with the Sophos Firewall console menu
  3. Go to 5. Device Management > 3. Advanced Shell
  4. Run the following commands:
    • nvram get "#li.serial"
      • The serial number of the XG firewall is then displayed
    • nvram get "#li.master"
      • if output of nvram get "#li.master" is YES as shown below, then the XG firewall is the initial HA primary Node:
        XG210_WP02_SFOS 17.5.9 MR-9# nvram get "#li.master"
        YES

Mine says NO.

So went to transfer the license in the Myportal, and the say:

No Eligible Target Devices 

We’re sorry, no eligible target devices could be found for this source license. For a device to be eligible it must:

  • Be registered by you (i.e. not shared with you)
  • Have no existing paid-for subscription licenses
  • Be of the same or equivalent model to the source device

This has probably to do with the Original Aux appliance, it has a enhanced support license, so i can not do the swap of license.

Can anybody help, we have no anti spam and other protection now.

Regards, 

Bart van der Horst

Top Replies

Parents Reply Children
No Data