I am setting up a docker container called netbootxyz. I want to be able to pxe boot in my home network. Luckily, there is netbootxyz container, but I am not sure how to set it up on the firewall side. On the support page of netbootxyz, it says:
Application Setup
To use this image you need an existing DHCP server where you can set this TFTP server as your DHCP boot destination. This image does not contain a DHCP server nor do we aim to support one in the future...
Under Network/ DHCP, there doesn't seem to be options for this. It also sites examples for other firewalls:
Router Setup Examples
PFSense
Services -> DHCP Server
Set both the option for "TFTP Server" and the options under the Advanced "Network Booting" section.
- check enable
- Next server- IP used for TFTP Server
OPNsense
Services -> DHCP Server
Under the Advanced "Network Booting" section.
- check enable
- Next server- IP of docker host
Unifi Security Gateway (with the controller)
Networks -> LAN (or the network you want to boot from) -> ADVANCED DHCP OPTIONS
- tick Enable network boot
- Server- YOURSERVERIP
Any suggestions? Workarounds welcome as well.
This thread was automatically locked due to age.