This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

APX120 does not show up on pending access point list

I'm trying to connect my APX120 to a XG86w firewall.

The firewall is licenced with the basic licence and very basically configured with briged ports (lan and wireless). Firmware is updated.

A DHCP Server is configured and the access point is getting an IP and also showing up in DHCP client list.

But... it is not showing up in pending access point list..... Any ideas?



This thread was automatically locked due to age.
Parents
  • Just to be sure, the AP Firmware on XG is update to date? 

    Could you start a Central Eval, register this APX120 to Central wireless and update the firmware? Some APX120 came with very old firmware, which does not know XG to begin with. 

    __________________________________________________________________________________________________________________

  • I could solve the issue now.

    In packet capture I filtered traffic corresponding to the ip of the access point. Which told me, there is a firewall violation for traffic from access point to 1.2.3.4.

    Then I created a temporary firewall rule with any to any. After that, the access point showed up on wireless access points.

Reply
  • I could solve the issue now.

    In packet capture I filtered traffic corresponding to the ip of the access point. Which told me, there is a firewall violation for traffic from access point to 1.2.3.4.

    Then I created a temporary firewall rule with any to any. After that, the access point showed up on wireless access points.

Children
No Data