This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

cannot connect to device on specific port over LAN

Hello all.. I switched to a sopos firewal from netgear and ever since I have been unable to get my phone system's management software to connect to the pbx box.. it attempts to open a connection on port 35300 and simply comes back with the message "cannot open LAN port"

Is there a setting that might cause this on this device?

This thread was automatically locked due to age.

Parents

0 rfcat_vk over 4 years ago

Hi,

you need to create a firewall rule to allow the traffic out on that port.

Ian

XG115W - v20 GA - Home

XG on VM 8 - v20 GA

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 Luc Bouillon over 4 years ago in reply to rfcat_vk

out to where? it's a PC on the LAN trying to access a device also inside the LAN..
Cancel
Vote Up 0 Vote Down

Cancel
0 LuCar Toni over 4 years ago in reply to Luc Bouillon

XG is a stateful firewall. You need for every connection through XG a Firewall rule.

Even LAN to LAN.

But not, if those clients are in the same subnet without XG interaction (for example both on the same Switch level).

__________________________________________________________________________________________________________________
Cancel
Vote Up 0 Vote Down

Cancel
0 Luc Bouillon over 4 years ago in reply to LuCar Toni

I only have one subnet per location, and both these devices are in the same location.. .

but anyway, kets assume that's the problem, if I wanted to create a rule that any PC on the LAN could access 192.168.2.10 on port 35300 how would I go about it? I would like to be able to access it across the VPN as well, but local is most important at this time.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Luc Bouillon over 4 years ago in reply to LuCar Toni

I only have one subnet per location, and both these devices are in the same location.. .

but anyway, kets assume that's the problem, if I wanted to create a rule that any PC on the LAN could access 192.168.2.10 on port 35300 how would I go about it? I would like to be able to access it across the VPN as well, but local is most important at this time.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data