This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

multiple Vlans trought WS500

hi,

i have ws500 on bridge mode i want to know if it is possible to configure the Sophos interfaces as trunk link to carry multiple vlan bcz the sohphos is btwn a cisco switch and ASA firwall

thank you .

This thread was automatically locked due to age.

Parents

0 FormerMember over 5 years ago

No, it doesn't do VLANs. Also, it is not a good idea to put the appliance between the switch and the ASA like that if you want the ASA to inspect all the vlans. Instead, use WCCP. That way the ASA can pass the web traffic to the WS500 on a per connection basis and the ASA is handling all the VLAN information.

http://wsa.sophos.com/docs/wsa/cg/pdf/swa_cg.pdf
Cancel
Vote Up 0 Vote Down

Cancel
0 hamid hassaine over 5 years ago in reply to FormerMember

Thank you,

If i want to use WCCP, the appliance must be in the same subnet as ASA (mean the gateway)? Ans is it possible to use wccp for multiple vlen
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 hamid hassaine over 5 years ago in reply to FormerMember

Thank you,

If i want to use WCCP, the appliance must be in the same subnet as ASA (mean the gateway)? Ans is it possible to use wccp for multiple vlen
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 FormerMember over 5 years ago in reply to hamid hassaine

There is two options available for config - L2 and GRE

If you do L2, it has to be the same subnet

If you do GRE it can route through other L3 devices to the ASA

You can find all the information needed in the Web Appliances UI:

config > network > WCCP

Then click on Help in the top ribbon
Cancel
Vote Up 0 Vote Down

Cancel