Thread Info
  • State Verified Answer
  • Locked Locked
  • Replies 4 replies
  • Subscribers 4 subscribers
  • Views 10880 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

New installton with wireless AR928X and lan card

FrancoisDesfosses

Hi group.

i just installed the asg-9.351-3.1.iso (ASG Software) to a computer. it's running firmware version 9.351-3.

once installed, i went on the web gui, to finish setup and when it was asking for network, it did not displayed the WIRELESS card.

i do see my LAN card perfectly, the goal for the LAN is to be connected to the INTERNET using PPPoE and i want to use the WIRELESS card to connect my home devices through my router.

my first big problem is that i do not see my network interface wireless in the webadmin. i went on SSH, and i do see that the operating system dected it, at least, i think, the LSPCI command show me

20:00.0 Network controller: Atheros Communications Inc. AR928X Wireless Network Adapter (PCI-Express) (rev 01)

so my goal now is to get my CABLE MODEM hooked up in the sophos pc. and then i want to connect the wireless as a client to my network, then i will use my dhcp router to tell to use that wireless IP as a proxy server.

how can i make sophos see my wireless card in the webadmin ?

thank you and best regards.



This thread was automatically locked due to age.
Parents
  • 0
    Salut Francois, and welcome to the UTM Community!

    I recall that others have posted here about success with an Atheros card. Try a Google on site:community.sophos.com Atheros

    Cheers - Bob
     
    Sophos UTM Community Moderator
    Sophos Certified Architect - UTM
    Sophos Certified Engineer - XG
    Gold Solution Partner since 2005
    MediaSoft, Inc. USA
  • 0 in reply to BAlfson
    Merci Bob!, unfortunatly, i did not found any good answers... i will keep searching and will post results here!

    in the meantime, i used a USB to LAN adapter, which is recognized. so now at least, i have 2 NIC working. the downside is that during install of the ISO, it did not recognized it and therefore, there is no config made. so it looks i have to configure LAN and INTERNET and make the bridge thingy. this is getting a little bit harder! so i think i will make a VM with 2 nics, install UMT on the VM and then compare the settings, becuase right now, nowthing working!
Reply
  • 0 in reply to BAlfson
    Merci Bob!, unfortunatly, i did not found any good answers... i will keep searching and will post results here!

    in the meantime, i used a USB to LAN adapter, which is recognized. so now at least, i have 2 NIC working. the downside is that during install of the ISO, it did not recognized it and therefore, there is no config made. so it looks i have to configure LAN and INTERNET and make the bridge thingy. this is getting a little bit harder! so i think i will make a VM with 2 nics, install UMT on the VM and then compare the settings, becuase right now, nowthing working!
Children
No Data
Unfiltered HTML