Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 10 replies
  • Subscribers 1 subscriber
  • Views 2715 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Time definitions for wireless networks

wingman
Hi All

I am trying to set up time definition that spans across midnight but I am not able to do so. I would like to stop the Wireless from 01:00 until 07:00 in the morning

I have therefore created two network objects as per pic attached. However, only one of them seems to be active (green one)

Is there a better way of achieving this?

Thanks
Pantelis


This thread was automatically locked due to age.
Parents
  • 0
    Is there a way (either via ssh or via the UTM management interface) to REBOOT an AP50 without physically walking over there to unplug it? As we have a few AP50s that like to go "brain dead" from time to time and I am not always at the site to reboot them it would be wonderful to be able to do this remotely...
  • 0 in reply to luckman212
    Is there a way (either via ssh or via the UTM management interface) to REBOOT an AP50 without physically walking over there to unplug it? As we have a few AP50s that like to go "brain dead" from time to time and I am not always at the site to reboot them it would be wonderful to be able to do this remotely...


    Not sure if this is possible from UTM, but if you have managed switch (and use PoE) you can shut down the switchport the AP50 is connected to and then re-enable the port again.

    Managing several Sophos firewalls both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.

Reply
  • 0 in reply to luckman212
    Is there a way (either via ssh or via the UTM management interface) to REBOOT an AP50 without physically walking over there to unplug it? As we have a few AP50s that like to go "brain dead" from time to time and I am not always at the site to reboot them it would be wonderful to be able to do this remotely...


    Not sure if this is possible from UTM, but if you have managed switch (and use PoE) you can shut down the switchport the AP50 is connected to and then re-enable the port again.

    Managing several Sophos firewalls both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.

Children
No Data
Unfiltered HTML