SG125, not picking my AP 100.

Question

my SG125 has full-guard license, wireless protection is turned on, AP is getting IP from DHCP (DHCP hosted on SG125) i have tried 3 different AP's (All 100's) however it is going through a Juniper EX2200, im pretty sure i configured the port correctly. (need to broadcast 2 SSID's, each SSID on different Vlans and DIfferent DHCP servers). In short, The AP 100 is not listed in wireless protection>access points.

This thread was automatically locked due to age.

Scott_Klassen · Answer

At Wireless Protection > Global Settings > Global Settings, is the interface the AP is connected to in the Allowed Interfaces list?

To announce itself, APs will send a packet to IP 1.2.3.4, which the UTM will capture and recognize. Make certain these are being forwarded by your Juniper. They communicate with each other via TCP 2712. so make certain this is allowed as well.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1