This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

New Ethernet Interface reports error on UTM

Using 9.705-7

Trying to move away from a DSL connection on Eth1 to an Ethernet connection.

Even when I shut down the DSL line, I cannot configure a straight ethernet connection on Eth1 - just throws up an error on Save

Interface type requires exclusive access to the network interface

I have looked and cannot find anything in the current search specific to this exact query.

Anyone any ideas?

Nick

This thread was automatically locked due to age.

Parents

0 BAlfson over 3 years ago

Hi Nick,

Do you also have a VLAN Interface defined on eth1?

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 NicholasChase over 3 years ago in reply to BAlfson

Shouldn't need to, have dual NICs so eth0 is Lan and eth1 should just be Ethernet or at least that is my understanding.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 3 years ago in reply to NicholasChase

Please show a picture of the 'Interfaces' tab, Nick.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel
0 NicholasChase over 3 years ago in reply to BAlfson

Hi Bob

Sorry about the delay - been away for a few days - screen shot below.

Now I know currently the External (WAN) is showinf UP and obviously on, however the same red error message is received, even if I toggle that 'off'. unplug the modem, and reboot my Sophos UTM so that the NIC card cannot possible detect anything present.
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 3 years ago in reply to NicholasChase

I'm even later, Nick! Visiting family and turning cranks. ;-)

Yes, you'll need to delete the "Draytek" interface definition.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 3 years ago in reply to NicholasChase

I'm even later, Nick! Visiting family and turning cranks. ;-)

Yes, you'll need to delete the "Draytek" interface definition.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data