Hi following setup, simplified to explain
an UTM on an sg320 with a red sd-20
managed switch with vlans on main side
managed switch behind red with vlans
red is setup in split mode
Main office 10.0.0.0/16 ( vlan 1 )
remote side behind…
Hi , I have deleted my RED configuration of the Firewall and when I set it up again I get the following error message: The specified unlock code does not match this device
Has the unlock code changed? Please reset my SD-RED.
My SD-RED 20 ID: R20001GCH8HJQ9F…
My team purchased several of the 3/4G Modules for the RED 60 devices and they are not working. The modems have been verified to work in a XG 125 and pass traffic in that UTM fine but when connected to the RED 60 we get nothing. Verizon is supported as…
After I set up a RED20, I plugged an AP into it, as I wanted to have an AP behind the RED20. I have it in Split-Tunnel Mode. The issue I had was that the AP would not show up in the list of new APs to authorize, on the UTM side. I read many many posts…
Hello everybody - I am new to the Sophos community and I could not find a solution to my problem in the existing posts. That might be an indication that I might be missing on something very basic.
In our office we have a SG135. Two SD-RED 20 devices…
Hello there,
I have a SD-RED 20 which dows not boot anymore.
The system LED flashes for about 30 seconds and then it turns off again and 30 seconds later it turns to flashing again. The process starts all over again and again. Even a connected LTE…
Hi,
I am trying to use the 4G Module in a RED 20/60 Device. Configuration is set with 3G/UMTS failover and APN / Dial String set correctly.
Using the USB-Dongle E3372 it is working and connecting via failover. Then I put the Sim-Card from the E3372…
