After I set up a RED20, I plugged an AP into it, as I wanted to have an AP behind the RED20. I have it in Split-Tunnel Mode. The issue I had was that the AP would not show up in the list of new APs to authorize, on the UTM side. I read many many posts…

Hello, This has been going on for a little over a month now and seems to be getting worse. We have a RED 50 connected to our UTM 220 and following recent firmware upgrades (I think) it has become unstable. I see lots of other similar cases out there…

I have an internal client vlan (VLAN12) that I need to pass to a remote office. I purchased a RED50 because the literature says, it can handle vlan’s. Only, I’ve tried every which way that is suggested by the Sophos Community and I cannot get it to work…