• How to set up SOPHOS AP behind a RED10 RED20 RED50 RED60 device.

    After I set up a RED20, I plugged an AP into it, as I wanted to have an AP behind the RED20. I have it in Split-Tunnel Mode. The issue I had was that the AP would not show up in the list of new APs to authorize, on the UTM side. I read many many posts…

  • Red 50 - and PF Sense

    Hello, I am wondering if someone may have some good ideas here, We are using the RED 50 for site to site VPN on our corporate level. But we also have to run PFSence VPN to connect to all field equipment that we work with. Today I have to use 2…

  • Red 50 Standard/Split AP55

    Hi, i have a question. I have a Sophos SG210 an did set up RED50 in standard/split mode. Port mode: Switch Behind the RED50 is an AP55 with 3 wireless LAN (the same which i have @ the SG210) i am able to access all 3 WLAN and use the internet…

  • RED 50 Dropping Connection

    Hello, This has been going on for a little over a month now and seems to be getting worse. We have a RED 50 connected to our UTM 220 and following recent firmware upgrades (I think) it has become unstable. I see lots of other similar cases out there…

  • RED50 - VLAN and DHCP not working

    I have an internal client vlan (VLAN12) that I need to pass to a remote office. I purchased a RED50 because the literature says, it can handle vlan’s. Only, I’ve tried every which way that is suggested by the Sophos Community and I cannot get it to work…

  • Not able to ping Internal DNS Server through Red 50 Tunnel

    I have a Red 50 set up for standard / split and I have the DHCP set for a different subnet 172.17.44.0/24 than my main subnet of 172.17.43.0/24. The gateway and dns for the DHCP group are the Sophos Red IP Address 172.17.44.254 I am able to connect…
Unfiltered HTML