• How to set up SOPHOS AP behind a RED10 RED20 RED50 RED60 device.

    After I set up a RED20, I plugged an AP into it, as I wanted to have an AP behind the RED20. I have it in Split-Tunnel Mode. The issue I had was that the AP would not show up in the list of new APs to authorize, on the UTM side. I read many many posts…

  • Bring VLANS from our Datacenter to the Remote-Office (Red 15w)

    Is it possible to do the following: We have got a lab-environment in our datacenter. We installed a Sophos UTM and defined multiple VLANS which are attached to the VMs on our Hyper-V-Host. In our remote-office is a Sophos RED15W, connected via RED-Connection…

  • RE: RED15w Access Point not showing up as pending access point

    Hi Christian I've got exactly the same Issue/ Problem which you described. The only difference: If I delete the Red15w, connect it to another UTM (which changes the unlock code), delete it there and connect it to the first UTM again (which again changes…

  • RED15w (Standard/Split mode) Wifi Access guest only subnet no access to anything but the internet

    Hello, I'm wanting to setup a RED 15w in Standard/split mode back to my UTM 9 for my remote users at our remote terminal sites but have the Wifi setup for only guest access to the internet. We are a trucking company and have drivers who want internet…

  • Setting up Wifi on a RED 15w connected to a SG-105w

    How am I suppodes to setup/enable the WiFi on a RED 15w connected to a SG-105w? The W-Lan on this remote UTM is already up and working. In the Admin interface, I can see the interface wlan0 (which is enabled, working and bridged to eth0); as well as…
Unfiltered HTML