Hi i just had a problem with my RED device i want to share. The same problem with AP. I tried to connect the RED device with my firewall but faild. With another firewall it worked fine. RED LED error code was No configuration available or firmware update…
After I set up a RED20, I plugged an AP into it, as I wanted to have an AP behind the RED20. I have it in Split-Tunnel Mode. The issue I had was that the AP would not show up in the list of new APs to authorize, on the UTM side. I read many many posts…
Hello,
I am wondering if someone may have some good ideas here,
We are using the RED 50 for site to site VPN on our corporate level. But we also have to run PFSence VPN to connect to all field equipment that we work with.
Today I have to use 2…
If I have to connect 1000 remote points with RED devices, which UTM do I have to choose? Or if the answer is a Virtual UTM, wich configuration do I need? Thanks
UTM is going to provide access only to the RED devices, no more functionalities.
Is it possible to do the following:
We have got a lab-environment in our datacenter. We installed a Sophos UTM and defined multiple VLANS which are attached to the VMs on our Hyper-V-Host. In our remote-office is a Sophos RED15W, connected via RED-Connection…
Hi,
is it possible to create a tunnel between two or more red devices directly (without passing data from one RED to the UTM and back to the other RED)?
Hello everyone,
I just added a RED10 to our UTM9 and chose Standard/Unified mode as we need the remote office to be working via the local office's public IP address.
However, the remote office's clients shall not be able to access devices such as…
Hallo zusammen,
habt Ihr das Problem mit den REDs noch?
Bei uns SG330 HA / RED 15 - FW 9.402-7 tritt genau dieses Problem auf. Nach einen DSL Reconnect auf der RED Seite wird die RED zwar als Online angezeigt es geht aber kein Traffic über den Tunnel…
Hi all,
Apologies if this has already been covered, but I could not find a definitive answer.
We have an SG230 at the Corporate Head Office and a number of RED 15w in staff member's homes.
Our SG230's primary WAN link is a 100Mbit/sec in both…
Habe ein identisches Problem hier aber mit einer Red50.
Nach Löschen und Neuanlage der Red50 geht es ganz normal.....bis zum nächsten Stromausfall.
Vielleicht hat einer einen Tipp. Dem Hinweis vom Support auf die 9.4er Version upzudaten und zu hoffen…
Sophos RED15 not booting properly, System light is on, Router is blinking - somtimes it comes on and then no internet connection is possible and the red is restarting.(i can see the lease on the DHCP server but RED ist never pingable) DHCP in the network…
Hi,
My setup is below:
UTM 9.351-3
RED15 in location in Transparent / Split, set to DHCP
in the main office when the Internet drop for a seconds then we can't connect to the RED device anymore. it has to be rebooted.
Is there any way to fix…
