This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED devices per UTM - Limit/Maximum Number

Hello folks,

Is there a limit (maximum number) of RED devices you can attach per UTM?

Only documentation I've found with a similar information was under the Partner Portal, in the link below, which states a Recommended number of RED devices per UTM in regards to sizing but there is no information implying a maximum limit.

partnerportal.sophos.com/.../sophosreden.pdf

Best Regards,

This thread was automatically locked due to age.

Parents

+1 sachingurung over 6 years ago

Hi,

The recommended numbers of RED that can be connected to the UTM SW/Hardware both is 600.

Thanks

Sachin Gurung
Team Lead | Sophos Technical Support
Knowledge Base | @SophosSupport | Video tutorials
Remember to like a post. If a post (on a question thread) solves your question use the 'This helped me' link.
Cancel
Vote Up 0 Vote Down

Cancel
0 Thiago Palmeira over 6 years ago in reply to sachingurung

Hello sachingurung,

I want to know if there's a limit to this number, not the recommended value. Reason is I need to specify this via documentation in a customer bidding but can't find the information anywhere else.
Cancel
Vote Up 0 Vote Down

Cancel
+1 sachingurung over 6 years ago in reply to Thiago Palmeira

The limit is 799 but the recommended value is as stated in my previous response.

Sachin Gurung
Team Lead | Sophos Technical Support
Knowledge Base | @SophosSupport | Video tutorials
Remember to like a post. If a post (on a question thread) solves your question use the 'This helped me' link.
Cancel
Vote Up 0 Vote Down

Cancel
0 Thiago Palmeira over 6 years ago in reply to sachingurung

Thank you!
Cancel
Vote Up 0 Vote Down

Cancel
0 Stephen Gultig over 5 years ago in reply to sachingurung

In response to this thread, you have given the recommendations to physical devices so the question in reverse would be ....

If I am connecting 100 REDS, each with a maximum 5 Mbps (average1Mbps) back to a hosted virtual appliance, what should the specifications be on the virtual appliance?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Stephen Gultig over 5 years ago in reply to sachingurung

In response to this thread, you have given the recommendations to physical devices so the question in reverse would be ....

If I am connecting 100 REDS, each with a maximum 5 Mbps (average1Mbps) back to a hosted virtual appliance, what should the specifications be on the virtual appliance?
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 BAlfson over 5 years ago in reply to Stephen Gultig

Hi Stephen and welcome to the UTM Community!

That depends on what else the UTM is doing. I recommend that you work on this with a Sophos presales engineer and that you work via email so that Sophos' recommendation is written.

Each RED tunnel uses as many resources as an SSL VPN tunnel. My guess is that, to be safe, you would want 12 cores and 24GB of RAM, but, again, ask Sophos.

Cheers - Bob

Sophos UTM Community Moderator
Sophos Certified Architect - UTM
Sophos Certified Engineer - XG
Gold Solution Partner since 2005

MediaSoft, Inc. USA
Cancel
Vote Up 0 Vote Down

Cancel