This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED Devices and Version 8

Greeings All,

This is the first time I tried to configure a RED device under version 8 and I can't seem to find where you define the subnet for the interface. The "Base IP" found on version 7 used to define the subnet seems to be missing. The help screen does not appear to be updated from version 7. BTW, the RED workes great on my version 7 device. What am I diong Wrong?

Thanks in advance for everyone's help.

This thread was automatically locked due to age.

Parents

0 ButtonPuncher over 14 years ago

On version 7, you could go to Network -> Interfaces and change the Netmask setting to change the RED's subnet. Is there a similar setting on version 8?

I hope that helps.

BP
Cancel
Vote Up 0 Vote Down

Cancel
0 stoner over 14 years ago in reply to ButtonPuncher

Thank you BP for your reply and I can't seem to find the option to create any interface/subnet under version 8. When you configure the RED device under version 7, the interface is automatically created by the configuration agent based on your initial "Base IP" entered during the configuration process which can then be edited as you suggest. On version 8 there doesn't seem to be an option to create the subnet/interface or "Base IP" in the first place.

Thanks
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 stoner over 14 years ago in reply to ButtonPuncher

Thank you BP for your reply and I can't seem to find the option to create any interface/subnet under version 8. When you configure the RED device under version 7, the interface is automatically created by the configuration agent based on your initial "Base IP" entered during the configuration process which can then be edited as you suggest. On version 8 there doesn't seem to be an option to create the subnet/interface or "Base IP" in the first place.

Thanks
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data