I'm trying to setup the Split Tunnel configuration, using the RED Initial Setup Guide from the kb (https://support.astaro.com/support/index.php/RED_Initial_Setup).
As part of this setup, a static route must be set to forward all traffic to the connected LAN port of the RED device. This is where the problem seems to arise. None of the 4 LAN ports on the RED device make a DHCP request, so they don't get a LAN IP that I can use to setup a standard static gateway route. The WAN port does make a request and gets a local LAN ip just fine.
So, what's the trick here? I need something to forward the traffic to on the remote network router.
There may also be NAT issues at work here, as there are three separate subnets involved. The ASG the RED device is registered to is at work and the work LAN is 192.168.2.0, the RED virtual interface network (RVIN) on the ASG is 192.168.100.0, and the home network the RED device is physically at is 192.168.1.0 (using Astaro at home as well). I need to be able to access network resources at work from home through the RED. If I connect a PC at home directly to a RED LAN port, it is given an IP from the DHCP server setup on the ASG at work that's assigned to the RVIN interface and everything works.
If somebody has gotten the split tunnel setup described in the guide to work, please post the steps you had to take to finagle it. [:)]
This thread was automatically locked due to age.
