This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Replace RED (how to take over the config)

Hi,
what happens with the config, if a RED gets defekt and have to replace. For fault tolerance we whant to have a secound RED as cold standby.
Following questions did i have:

- Can I configure a secound RED with the same SubNet?
- Can I replace the RED ID and unlook Code in an existing configuration?

What is the best way.

thanks for help
yours
Björn

This thread was automatically locked due to age.

Parents

0 Jack Daniel over 14 years ago

RED configurations are keyed to the device ID, so that cannot be changed from one device to another.
Cancel
Vote Up 0 Vote Down

Cancel
0 maygyver over 14 years ago in reply to Jack Daniel

You can Transfer config. Just add the New RED to Astaro. But do Not use Automatik config Mode.

After that went to to the old Interface config and change it to the New Hardware (RED).

Astaro user since 2001 - Astaro/Sophos Partner since 2008
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 maygyver over 14 years ago in reply to Jack Daniel

You can Transfer config. Just add the New RED to Astaro. But do Not use Automatik config Mode.

After that went to to the old Interface config and change it to the New Hardware (RED).

Astaro user since 2001 - Astaro/Sophos Partner since 2008
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data