This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

RED-60 endless booting sequence (System/Router)

Hello,

I try to setup a brand new SD-RED-60 but facing endless error leds loop.

On local site (192.168.1.0/24), Sophos SG125 configuration :



On distant site (192.168.0.0/24), the RED-60 boots the following sequence :
- System led blinking green...
- System led solid green, Router led blinking green (long time)...


- System led solid red.

...while(1)


Router solid led is described in documentation as :

"Either an address has been received from DHCP, or static assignment, and appears valid. The gateway address is reachable."

Assuming blinking state is just before solid state (this never happens), I suppose RED cannot reach the local router gateway ?

Despite this endless booting sequence, a locally connected machine on distant site can ping the RED-60 on 192.168.0.191

So I deduce the distant configuration has been downloaded and is correctly applied ?

I cannot understand why the sequence cannot go further router led step.

Any idea ?

// ports forwarded on local site's router TCP 3400 <192.168.0.191 > 3400 + UDP 3410 <192.168.0.191 > 3410



This thread was automatically locked due to age.
Parents Reply Children
No Data