HI, had a search through the forums, but could not find a solution that I suspect is easy to setup, just not completely clear on location for configuations.
Dual Wan connections I am wanting to load balance.
Both Wan connections are dhcp and receive a fixed IP that are in the same network range/subnet, and so have the same gateway address.
wan1 IP: 220.127.116.11/25
wan1 GW: 18.104.22.168
wan2 IP: 22.214.171.124/25
wan2 GW: 126.96.36.199
I have gone back to my ISP provider and ask them to to put the 2 Wan connections on 2 different networks, but have not had a response back yet.
I have checked a few question/responses in the community forums, and I an thinking it may be possible to do this using zones? but not sure if this is possible or how to with the UTM 9.x
Hi Stephen and welcome to the UTM Community!
WebAdmin and the configuration daemon automatically create routes between the subnets defined on the UTM's interfaces. As Dirk said, it appears that you have created a routing conflict as you have the same 188.8.131.52/25 subnet on both interfaces.
Unlike most routers, the UTM doesn't require the default gateway to be in the subnet defined on the interface. The easiest solution would be to get fixed IPs like 184.108.40.206/30 and 220.127.116.11/30 and assign both a default gateway of 18.104.22.168.
Cheers - Bob