• How can I find out how many and what are the devices IPs currently connected to LAN

    Under Wireless Protection I Can click at Wireless Clients to see what clients are connected to the WiFi. Can I do the same for LAN devices? I do have DHCP enabled on the UTM.
  • Interface communications not working

    Hello all... New to Sophos I'm very excited to have found this free UTM for home use as I simply do not feel I am in control of my home network. I have set up the Sophos on a Dell Optiplex 780 (I think) and added NICs to a total of 6 interfaces. What…
  • forbid Access to the Webinterface of the Router for a special VLAN using the SG105

    Hi, in won't allow (forbid) the Access to the Webinterface of the Router for the Guest-VLAN. But if I block all Traffic on Port 80, no is able to surf in the Internet. What else should I do? For good Ideas very thankful.
  • restrict the Access for multiple Networks over SG105

    Hi, Just a “simple” Question, but I only use my Sophos SG 105 at Home, and so I’m no Specialist. I’ve two Networks (192.168.131.0 and 192.168.179.0) on two different Network-Cards (eth1 and eth2). The Access to the WAN on eth0 works for both Networks…
  • Configuring Vlan beetween Tplink TL-SG108E and Sophos UTM home V9

    hi all, i have a few problems with the configuration of a vlan beetween sophos utm home and the tplink switch. my sophos has two ethernet interface, one is for ppoe and the other for the local network and the vlan, i set the vlan id at 100 and do…
  • Open Resolver Check

    I've been experiencing Open DNS Resolver attacks and would like to ensure my UTM isn't acting as an open resolver. I've tested through following means dig +short test.openresolver.com TXT MYIP Running this from outside the network returns ;; connection…
  • No internet connecting via ETH0 (WAN interface)

    Hello everybody, my problem is, that i can´t connect to the internet via eth0 (wan interface). the dhcp and dns server on the utm is also activ and i get an dhcp adress from the utm, but i can´t connect to the internet. anyone who has the same problem…
  • Additional Address stops responding

    Posting this question again on the new forum.. Here is the link to the old: https://www.astaro.org/gateway-products/network-protection-firewall-nat-qos-ips/59993-additional-address-stops-responding.html Still battling this problem. Wondering if it is…
  • add 2 more LAN's to go out firewall and use HTTP/HTTPS web inspection?

    Hi, If I am using 192.168.0.0/24 and I have two neighbors 192.168.61.0/24 and 192.168.62.0/24 are there a LOT of places in the UTM 9.3 product I have to create this network and broadcast and link them to the firewall or web filter rules? Thanks…