I have two servers which I have been running UTM 9.3xx on using software version. Both are the same hardware type and brands with 3 nics.
I recently loaded UTM 9.356 on one and tried a restore. The restore went through as normal but only setup ONE nic, for the Untrusted setup and it was on a different NIC than was on the restore.
The other two NICS were listed during the install and show up in the Webadmin hardware screen. I went in and set up my other interfaces and all works now.
I did a backup of this unit and then performed the new install of the second server with the same UTM 9.356 and then did a restore from the UTM 9.356 server that I just created.
I had the exact same results as my first server and restore.
The first thing was that the installer renumbered the NICs. EX: eth0 is now eth2 etc
How can I fix these units so that I can get a proper backup and then be able to do a proper restore?
This thread was automatically locked due to age.
