Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 4 subscribers
  • Views 3837 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

I can't get the static IPs to take in my UTM

ChrisStanley

I received a block of static IPs from Century Link.  I add the GW IP to the UTM external interface and change the notation to /29, but the UTM changed it back to /32 and I can't get past that.  I can get more information if you need it, just tell me what would help.

Thank you.



This thread was automatically locked due to age.
Parents
  • 0

    You can't add IPs to a UTM interface like that.  Add the first to the interface, then setup the remaining ones on the Additional Addresses Tab.

    __________________
    ACE v8/SCA v9.3

    ...still have a v5 install disk in a box somewhere.

    http://xkcd.com
    http://www.tedgoff.com/mb
    http://www.projectcartoon.com/cartoon/1
  • 0 in reply to Scott_Klassen

    Sorry for the delay.  I have a block of three IPs.  I plugged one of those IPs into the UTM interface and changed the network to /29 and saved it.  I left Default GW checked.  It then placed the interface into a down status and it won't "reconnect".  Looking at the interface, it shows the wrong default GW.  There doesn't seem to be a place for me to enter the GW that I need.  That's why I tried the static route.  I've entered statics on different UTMs before as an MSP but this is the first time I have tried to use Sophos to do that.  All of the other ones have IP Address, Subnet mask, and Default GW>  Sophos has IP address and subnet which is why I'm pretty confused about this.  After I tried that, I tried entering the GW that I received as the external WAN IP address and it still isn't working.

Reply
  • 0 in reply to Scott_Klassen

    Sorry for the delay.  I have a block of three IPs.  I plugged one of those IPs into the UTM interface and changed the network to /29 and saved it.  I left Default GW checked.  It then placed the interface into a down status and it won't "reconnect".  Looking at the interface, it shows the wrong default GW.  There doesn't seem to be a place for me to enter the GW that I need.  That's why I tried the static route.  I've entered statics on different UTMs before as an MSP but this is the first time I have tried to use Sophos to do that.  All of the other ones have IP Address, Subnet mask, and Default GW>  Sophos has IP address and subnet which is why I'm pretty confused about this.  After I tried that, I tried entering the GW that I received as the external WAN IP address and it still isn't working.

Children
Unfiltered HTML