This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WAN Failover

UTM 9. I have an a secondary interface that is over a slower connection but we do have some static routes pointing to that interface so it has to remain ON. however, I don't want it configured as a WAN connection unless our Main connection goes down. Is this possible?

This thread was automatically locked due to age.

0 sachingurung over 8 years ago

Hi Alan,

Configure the secondary interface as a Active Interface with 0 weight. Then you can create a Multipath rule as per the route requirement.

Thanks

Sachin Gurung
Team Lead | Sophos Technical Support
Knowledge Base | @SophosSupport | Video tutorials
Remember to like a post. If a post (on a question thread) solves your question use the 'This helped me' link.
Cancel
Vote Up 0 Vote Down

Cancel
0 AlanMayer over 8 years ago

The second I put the secondary interface into standby then the secondary interface goes to state of down - standby. So no traffic is going across this interface. Is this something I can accomplish using multipath rules? If so, how do I set it up?
Cancel
Vote Up 0 Vote Down

Cancel
0 sachingurung over 8 years ago in reply to AlanMayer

Hi Alan,

I have edited my previous post, please refer and update.

Thanks

Sachin Gurung
Team Lead | Sophos Technical Support
Knowledge Base | @SophosSupport | Video tutorials
Remember to like a post. If a post (on a question thread) solves your question use the 'This helped me' link.
Cancel
Vote Up 0 Vote Down

Cancel