Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 6 replies
  • Answers 1 answer
  • Subscribers 5 subscribers
  • Views 1463 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Non-bridgeable modem

CarlosNaldinho

I had a perfectly functional UTM setup but I was required to change my modem to one that can not be put in bridge mode.

I've been at this for a few hours and I can't figure put how to setup the WAN interface now that the modem is handling the authentication with the ISP. 

Can someone tell me if this is possible and even better what settings I should be using?



This thread was automatically locked due to age.
Parents
  • 0

    Ola Carlos,

    do you know the inside IP of your „Modem“?

    Mit freundlichem Gruß, best regards from Germany,

    Philipp Rusch

    New Vision GmbH, Germany
    Sophos Silver-Partner

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to PhilippRusch

    Yes. It is 192.168.2.1

    The issue is I don't know if this is possible and when I try changing the WAN interface to Ethernet which I figured would be the likely choice the entire UTM freezes up and it takes me a few reboots to deactivate the WAN interface.

    The modern (Bell Hub 2000) also has a WAN port and not sure if I should be using that or just one of the LAN ports on the modem.

    I have turned off all network services on the modem itself and also disabled the wifi but beyond that I can't seem to figure it out

  • 0 in reply to CarlosNaldinho

    I don‘t know about that model, but you need an „inside“ interface (LAN?) and one „outside“ interface (WAN?). What type of uplink do you have?

    Mit freundlichem Gruß, best regards from Germany,

    Philipp Rusch

    New Vision GmbH, Germany
    Sophos Silver-Partner

    If a post solves your question please use the 'Verify Answer' button.

  • 0 in reply to PhilippRusch

    Right, so the uplink used to be DSL (PPPOE) when I was able to put the modem into bridge mode -- not that I can't put the modem into bridge mode I don't know what type I should be using.

    The menu gives me 7 choices -- 3G/UMTS, DSL (PPPOA/PPTP), DSL (PPPOE), Ethernet, Ethernet Bridge, Ethernet VLAN, and Modem (PPP).

    Of those, I can rule out four as obviously not what I want and it seems to me that I should want Ethernet but that doesn't work -- The interface remains down and the UTM actually becomes non-responsive and it takes quite a bit of just rebooting to eventually be able to get back into the configuration panel.




  • 0 in reply to CarlosNaldinho

    Please show us an edit of your interface configuration of that ethernernet port on the Sophos.

    Mit freundlichem Gruß, best regards from Germany,

    Philipp Rusch

    New Vision GmbH, Germany
    Sophos Silver-Partner

    If a post solves your question please use the 'Verify Answer' button.

Reply Children
No Data
Unfiltered HTML