This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SMTPD not running properly since firmware update

since firmware update to 9.400-9 i have had some issues with the SMTPD not running (6 alerts since update) which means mail doesn't even come into the UTM logs.

I have rebooted and a flurry of mails come in, anyone else had issues?



This thread was automatically locked due to age.
Parents
  • Rebooted system, and after a while turned SMTP Proxy on again. Log is:

    2016:04:11-17:49:31 astaro1-2 smtpd[6028]: MASTER[6028]: (Re-)loading configuration from Confd
    2016:04:11-17:49:31 astaro1-2 smtpd[6028]: MASTER[6028]: Past 07:00:00, QR status one set to 'sent'
    2016:04:11-17:49:31 astaro1-2 smtpd[6028]: MASTER[6028]: QR two disabled, status two set to 'disabled'
    2016:04:11-17:49:33 astaro1-2 exim-in[6349]: 2016-04-11 17:49:33 pid 6349: SIGHUP received: re-exec daemon
    2016:04:11-17:49:33 astaro1-2 exim-in[6349]: 2016-04-11 17:49:33 exim 4.82_1-5b7a7c0-XX daemon started: pid=6349, no queue runs, listening for SMTP on port 25 (IPv6 and IPv4) port 587 (IPv6 and IPv4) and for SMTPS on port 465 (IPv6 and IPv4)
    2016:04:11-17:50:00 astaro1-2 exim-out[14815]: 2016-04-11 17:50:00 Start queue run: pid=14815
    2016:04:11-17:50:00 astaro1-2 exim-out[14815]: 2016-04-11 17:50:00 End queue run: pid=14815
    2016:04:11-17:51:00 astaro1-2 exim-out[14873]: 2016-04-11 17:51:00 Start queue run: pid=14873
    2016:04:11-17:51:00 astaro1-2 exim-out[14873]: 2016-04-11 17:51:00 End queue run: pid=14873
    No mention of email being received from external or internal. No emails are sent or received while I have it on.
  • Hey, 

    we had the same error, after i killed the smtpd prozess and start the smtpd prozess all works fine ;-)

Reply Children