Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 7 replies
  • Subscribers 9 subscribers
  • Views 19001 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPv6 on WAN

xeonic
Recently my ISP started to support IPv6 natively, they are handing out a /56 subnet via DHCPv6. My ISP provided router is currently working with IPv6 but I can't seem to get my UTM to grab an IPv6 address. 

I enabled IPv6 in 'Interfaces & Routing' and I have my WAN interface (eth0) set to both IPv4 and IPv6 default GW plus dynamic IP. 

Is there anything else I need to do?

I noticed that in the 'system messages' log, there are only entries for WAN IPv4 DHCP requests, there is nothing related to IPv6.

Thanks!


This thread was automatically locked due to age.
Parents
  • 0

    Hi Folks

    i´ve got the same problem. With Fritz.Box directly connected to router from "Deutsche Glasfaser" I get an IPv6 adress.

    With Sophos UTM9.3 i dont get an IPv6 address,

    In "Interfaces & Routing - IPv6" there is no IPv6 address, only "Native over eth1 - delegated präfix 2a00:xxxx:xxxx:xxxx::/56"

    What may be wrong?

    I restarted firewall, and i restarted router from provider. No changes at all

    greeting

    Christian

Reply
  • 0

    Hi Folks

    i´ve got the same problem. With Fritz.Box directly connected to router from "Deutsche Glasfaser" I get an IPv6 adress.

    With Sophos UTM9.3 i dont get an IPv6 address,

    In "Interfaces & Routing - IPv6" there is no IPv6 address, only "Native over eth1 - delegated präfix 2a00:xxxx:xxxx:xxxx::/56"

    What may be wrong?

    I restarted firewall, and i restarted router from provider. No changes at all

    greeting

    Christian

Children
No Data
Unfiltered HTML