This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Which Intel Core processor (Haswell) for 120+ Mbps with IPS and web filtering

I'm planning on replacing my current home UTM (Atom D2500CC) because it can't keep up with my internet connection (currently 120 Mbps awaiting upgrade to 150 Mbps down, 15 up).
I know I should go for at least an i3 processor, but maybe better an i5.

Looking at the current Haswell processors, I find a few T and S models which should be very low power (good for my electricity bill).

Are these good choices or is it better to choose a "normal" or a K version?

Processors I might be interested in:
i7-4770T, 45W TDP, 2.5GHz clock speed
i7-4770S, 65W TDP, 3.1GHz clock speed
i5-4570S, 65W TDP, 2.9GHz clock speed

Will the i7 (T) perform good enough for high-speed internet lines with IPS and web filtering enabled?
If not, how much difference would there be in performance between the i7-4770S and the i5-4570S? Clock speed only differs a little bit while the i5 is about €100 cheaper currently.


This thread was automatically locked due to age.
Parents
  • FWIW, I disabled Intel SpeedStep in the BIOS on my Z87 board and it stays at 3.4GHz now, with no change in power consumption.

    This does seem to result in the kernel message:
    boot.log:2013:12:19-16:58:03 fw [user:notice] rchal:  boot with 'CPUFREQ=no' in to avoid this warning.
    boot.log:2013:12:19-16:58:03 fw [user:notice] rchal:  Cannot load cpufreq governors - No cpufreq driver available
    boot.log::: Loading CPUFreq modules (CPUFreq not supported)

    However, that is probably to be expected with SpeedStep disabled.

    I'm not sure if the turbo modes are still working (will re-test later), but they are still enabled in the BIOS.

    Barry
Reply
  • FWIW, I disabled Intel SpeedStep in the BIOS on my Z87 board and it stays at 3.4GHz now, with no change in power consumption.

    This does seem to result in the kernel message:
    boot.log:2013:12:19-16:58:03 fw [user:notice] rchal:  boot with 'CPUFREQ=no' in to avoid this warning.
    boot.log:2013:12:19-16:58:03 fw [user:notice] rchal:  Cannot load cpufreq governors - No cpufreq driver available
    boot.log::: Loading CPUFreq modules (CPUFreq not supported)

    However, that is probably to be expected with SpeedStep disabled.

    I'm not sure if the turbo modes are still working (will re-test later), but they are still enabled in the BIOS.

    Barry
Children
No Data