[7.500][BUG][OPEN] Bandwith Monitor with PPPoE IF

Hi,

just installed 7.500 via automatic update on a ASG120 and recognised that the bandwith monitor is just display nothing on PPPoE interfaces. On internal interface this is working without any problems.....would be nice if the admin session itself would not be displayed. :-)

Setup:  eth0 - internal
           eth1 - wlan
           eth2 - pppoe with static ip (default gateway)
           eth3 - pppoe with dynamic ip

Btw. this display is showing only the volume (pkt in/out & bytes) and poorly not the bandwith ! :-)

greetz
  Claus

0 Astaro Beta Bot over 14 years ago

Astaro Beta Report
--------------------------------
Version: 7.500
Type: BUG
State: OPEN
Reporter: ClausP
Contributor: 
MantisID: 
--------------------------------

0 RFCat_vk_01 over 14 years ago in reply to Astaro Beta Bot

Hi,
Wingman has an outstanding bug report on this issue.

It was working under an earlier version, not sure what has gone wrong in the meantime.

The bandwidth values needs to be added in the network tab for each interface and then it only shows as green line on the Dashboard.

Ian M
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel