Hi, I am having some issues getting captive portal working on a Sophos APX 120 within Sophos Central. My requirements are as follows: Separate Guest SSID Client Isolation Traffic to be directed to bridged to a specific guest VLAN I…

I'm running Sophos XG with 5 APs (4 AP15 and one AP55). All are registered in Sophos Central an appear live and up to date in the Access Points page under wireless. But when I go to the Firewall Management Report Hub, under the Network section it shows…

Will APX Series management in Sophos Central remain free to use? Will AP6 Series require extra licensing for Sophos Central Management? DACH Region.

We have some internal and external wifis and some scheduled wifis for employees which are switched on and off during breaks. APs are managed through an XGS2300 When breaks begin and an SSID is activated via schedule, all Wifis turn off and on and APs…

It's mandatory for system performance to be able to disable the A,B and G bands that the APs are giving out. 2.4 GHz band should have controls to allow or deny 802.11b and 802.11g clients 5 GHz band should have controls to allow or deny 802.11a…

I am using the instructions to unbrick my APX120 from this post, but I have run into issues below: community.sophos.com/.../unbrick-apx120-break-bootdelay-0-recover-apx120 I can't seem to save the environment variables. When I run the "saveenv"…

After adding a new AP6 access point to my site on Sophos Central, I tried to add the AP to the floorplan, and it is greyed out and says "AP6 not available at this time". Seems really odd that this is not available...how different could it be from the…

Our access points have been offline since the early morning. The access points are integrated into Sophos Central. Resetting the device and re-registering it was also unsuccessful. This runs into a TimeOut. Are there currently problems with Sophos Central…

Hi, I found this tread, Wireless clients cannot communicate if connected to different APs (which was NEVER answered since over 2 years) I have been experiencing the same issue with my Natatmo security cameras for over a year now. According to their…

Currently, the built-in AP in XGS107W is basically a waste resource: I cannot assign SSID to the built-in AP from Central. Is it doable? Or it's not possible by design? If not possible from Central, can I make the built-in AP just like a regular APX…

Hello, In the last 3-4 months we have faced some very unwanted behavior when roaming devices between access points that we have in our environment. Our scenario and what we've already tried: -Both sophos firmware and access point firmwares are up…

Typical network ISP modem (bridged mode) -> Sophos firewall port 2 Firewall port 1 -> Sophos 1000 series switch port 28 (through an RJ45/SFP adapter) Switch port 2,4,6,8,10 -> APX120 1,2,3,4,5 VLAN Requirement Staff VLAN (10) Guest VLAN…

Hi All, We have 11 APs of different models: Model Qty FW Version Power/Data Source AP100C 4 v2.3.4-5 Cisco PoE Switch AP100X 1 v2.3.4-5 Power Injector/Cisco PoE Switch APX320X 2 v2.3.4-5 Power Injector…

I am facing internet speed slowness issue from APX 530. We have increased the bandwidth from 500 Mbps to 1Gbps but the problem is same, we are still not getting adequate speed, as mentioned about the APX530 can provide speed upto 1750 Mbps, but if there…

Hello, We need to perform wifi audits with sophos access points. I would like to be able to connect a computer to an SSID on an access point without the access point communicating with Sophos Central. How can I do ? Currently, when the access point…

Hello, we've setup 3 apx 530 access points and are having some issues with vlans and dns. Some background. We have 2 ssid's setup. One ssid is a guest network with no vlan. The other ssid is setup to authenticate logins with a ms nps server. And…

Hi, we notice a strage issue for a while now when WiFi clients are connected to a 802.1X RADIUS WiFi that contains APX320 and APX530 APs that are managed in Sophos Central. Occasionally it happens, when they move in the office and roam between the two…

Hi, we're setting up our firewall rules for sophos products following this KB: DomainsPorts Now we're in the situation support is requesting SSH access to the accesspoints. This was not working, except at one location where SSH was allowed outbound…

Hi all, while having 2 different Wi-Fi networks using Sophos APX (bridge to lan and separate zone) does not work, I decided to delete all wireless configurations and using the following kb to create 2 different Wi-Fi networks. https://support.sophos…

hi all, i have 22 access point sophos ap15c, the firewall is broken, i want to convert all these access point to be standalone what can i do? i try to reset but noway ,try to login by console but idont know openwrt password try to use flash…

i have Sophos AP100c, AP100x, Apx320x, apx 530. the challenge im having is that they keep on disconnecting to the internet at different times. i have tried rebooting or unplugging and reconnecting it back, it fixes the problem but later on goes offline…

Hey Guys, Is there perhaps a link where I can read how break out and network assignment works - With Wireless central when its at different locations . So for example Site A: SSID Local (How/Where/Who gives these clients that are connected to the…

"I was using the Sophos AP 55C with management on my Sophos Firewall UTM, but I won't be using the firewall anymore where I have the access points installed. Is there a way for me to manage them differently? They are already in EOL. What can I do ?"

Dear Community, someone of you has a idea why sophos doesent bring WPA3 support to the APX-Series? We deployed these access points at many of our customers. They will not unterstand why sophos is not interessted to bring this fundamental security…

Good day l have a APX 120, and XG135 Firewall . the access point is blinking amber, and later green . The access point is getting the IP address from the firewall, But the access point is not appearing on the pending list