I am using the instructions to unbrick my APX120 from this post, but I have run into issues below:
community.sophos.com/.../unbrick-apx120-break-bootdelay-0-recover-apx120
I can't seem to save the environment variables. When I run the "saveenv"…
After adding a new AP6 access point to my site on Sophos Central, I tried to add the AP to the floorplan, and it is greyed out and says "AP6 not available at this time". Seems really odd that this is not available...how different could it be from the…
Dear All, We recently disconnected our old Sophos XG3100 and also a bunch of Sophos AP (15C, 55C, 100C) and two RED50. The Sophos XG3100 appliances were cleaned using the (Reset to factory defaults) option on the firmware screen. But, for the APs and…
Our access points have been offline since the early morning. The access points are integrated into Sophos Central. Resetting the device and re-registering it was also unsuccessful. This runs into a TimeOut. Are there currently problems with Sophos Central…
Hi,
I found this tread,
Wireless clients cannot communicate if connected to different APs (which was NEVER answered since over 2 years)
I have been experiencing the same issue with my Natatmo security cameras for over a year now. According to their…
Das Thema wurde in den Foren ja schon einige Male behandelt, aber eine zufriedenstllende Lösung konnte ich da leider nicht finden.
Vielleicht hat der ein oder andere bereits neue Erkenntnisse/Lösungsvorschläge, welche uns weiterhelfen könnten.
Nach…
Currently, the built-in AP in XGS107W is basically a waste resource: I cannot assign SSID to the built-in AP from Central.
Is it doable? Or it's not possible by design?
If not possible from Central, can I make the built-in AP just like a regular APX…
Hello, In the last 3-4 months we have faced some very unwanted behavior when roaming devices between access points that we have in our environment.
Our scenario and what we've already tried:
-Both sophos firmware and access point firmwares are up…
Hi all,
Early next year I've got to replace an aging UTM and 20 AP broadcasters for a customer and seen the AP6 range is coming but its Sophos Central managed only.
The customer has a star topology, so HQ will have an XGS and other sites will have…
Hi All,
We have 11 APs of different models:
Model
Qty
FW Version
Power/Data Source
AP100C
4
v2.3.4-5
Cisco PoE Switch
AP100X
1
v2.3.4-5
Power Injector/Cisco PoE Switch
APX320X
2
v2.3.4-5
Power Injector…
I am facing internet speed slowness issue from APX 530. We have increased the bandwidth from 500 Mbps to 1Gbps but the problem is same, we are still not getting adequate speed, as mentioned about the APX530 can provide speed upto 1750 Mbps, but if there…
Hello,
We need to perform wifi audits with sophos access points. I would like to be able to connect a computer to an SSID on an access point without the access point communicating with Sophos Central. How can I do ? Currently, when the access point…
Hello,
After my APX was bricked, I have manually Installed then Firmware 11.0.020-1
https://community.sophos.com/sophoswireless/f/discussions/141850/wrong-firmware-installed-apx320
After that, the APX "come up" and I can see it in Wireless Accesspoint…
Hello, we've setup 3 apx 530 access points and are having some issues with vlans and dns.
Some background.
We have 2 ssid's setup.
One ssid is a guest network with no vlan.
The other ssid is setup to authenticate logins with a ms nps server. And…
Hi,
we notice a strage issue for a while now when WiFi clients are connected to a 802.1X RADIUS WiFi that contains APX320 and APX530 APs that are managed in Sophos Central. Occasionally it happens, when they move in the office and roam between the two…
Hello,
my APX320 was Bricked.
With Sophos Flash Tool I have installed the Firmware.
Probably I have installed an Wrong Image.
In directory /lib/firmware/IPQ4019/hw.1 are only APX120 exists.
In fact of this my APX320
- Boot with green LED…
Hi,
we're setting up our firewall rules for sophos products following this KB: DomainsPorts
Now we're in the situation support is requesting SSH access to the accesspoints.
This was not working, except at one location where SSH was allowed outbound…
Hello,
my APX 320 ist blinking RED Continuosly.
I Want do Flash it with Flash Tool.
Flash Tool Starts
Connect
End with error
Eventlog
Name der fehlerhaften Anwendung: Sophos Flashing Tool.exe, Version: 1.0.0.0, Zeitstempel: 0x5eeda7c4…
Hi all,
while having 2 different Wi-Fi networks using Sophos APX (bridge to lan and separate zone) does not work, I decided to delete all wireless configurations and using the following kb to create 2 different Wi-Fi networks. https://support.sophos…
hi all,
i have 22 access point sophos ap15c, the firewall is broken, i want to convert all these access point to be standalone
what can i do?
i try to reset but noway
,try to login by console but idont know openwrt password
try to use flash…
i have Sophos AP100c, AP100x, Apx320x, apx 530.
the challenge im having is that they keep on disconnecting to the internet at different times.
i have tried rebooting or unplugging and reconnecting it back, it fixes the problem but later on goes offline…
Hey Guys,
Is there perhaps a link where I can read how break out and network assignment works - With Wireless central when its at different locations .
So for example Site A: SSID Local (How/Where/Who gives these clients that are connected to the…
"I was using the Sophos AP 55C with management on my Sophos Firewall UTM, but I won't be using the firewall anymore where I have the access points installed. Is there a way for me to manage them differently? They are already in EOL. What can I do ?"
Dear Community,
someone of you has a idea why sophos doesent bring WPA3 support to the APX-Series?
We deployed these access points at many of our customers. They will not unterstand why sophos is not interessted to bring this fundamental security…