How to set up SOPHOS AP behind a RED10 RED20 RED50 RED60 device.
After I set up a RED20, I plugged an AP into it, as I wanted to have an AP behind the RED20. I have it in Split-Tunnel Mode. The issue I had was that the AP would not show up in the list of new APs to authorize, on the UTM side. I read many many posts…
No Wifi on RED15W(standard/split) after UTM 9.502-4 upgrade on SG230 via UMTS
Hello,
we seem to have a problem similar to this tread since 9.502-4, which might be caused by this fix:
> Fix [NUTM-7962]: [WiFi] Split traffic not working for wireless clients on RED15w after upgrade to v9.5
Our setup worked well in 9.500 and…
No local internet connection via Wifi on RED15W(standard/split) after UTM 9.500-9 upgrade on SG310
Hallo, since our upgrade to UTM 9.500-9 last week Friday following problem occurs: - We use a Sophos SG310 now with UTM 9.500-9. Connected via RED are several branches in Europe and one branch in the US all with a Sophos RED15W in standard/split mode…
RE: RED15w Access Point not showing up as pending access point
Hi Bob
Thanks for welcoming me!
I involved the Distributor's UTM-Support. Finally they gave up and involved the Sophos Support analyzing my UTM-Logs.
Outcome: The WLAN-Configuration which I pushed to the pending AP of the RED15w at the first (and…
RE: RED15w Access Point not showing up as pending access point
Hi Christian
I've got exactly the same Issue/ Problem which you described.
The only difference: If I delete the Red15w, connect it to another UTM (which changes the unlock code), delete it there and connect it to the first UTM again (which again changes…
Setting up Wifi on a RED 15w connected to a SG-105w
How am I suppodes to setup/enable the WiFi on a RED 15w connected to a SG-105w? The W-Lan on this remote UTM is already up and working.
In the Admin interface, I can see the interface wlan0 (which is enabled, working and bridged to eth0); as well as…