Hello, we have UTM 9 Firewall , we have a problem with RED 15, since yesterday one of RED15 cannot connect to our firewall, on saturday we installed the firmware update, after the update everything worked. we use another 3 REDs that work. here…

After I set up a RED20, I plugged an AP into it, as I wanted to have an AP behind the RED20. I have it in Split-Tunnel Mode. The issue I had was that the AP would not show up in the list of new APs to authorize, on the UTM side. I read many many posts…

If I have to connect 1000 remote points with RED devices, which UTM do I have to choose? Or if the answer is a Virtual UTM, wich configuration do I need? Thanks UTM is going to provide access only to the RED devices, no more functionalities.

Is it possible to do the following: We have got a lab-environment in our datacenter. We installed a Sophos UTM and defined multiple VLANS which are attached to the VMs on our Hyper-V-Host. In our remote-office is a Sophos RED15W, connected via RED-Connection…

Hello, we have two SG330 devices that operate in a hot-standby cluster. The internet connection in our main office, where the firewall cluster are located, is 50.000 Mbit/s SDSL (Up- and Download). If we use a new RED15w device on a good performing…

Hi all, Apologies if this has already been covered, but I could not find a definitive answer. We have an SG230 at the Corporate Head Office and a number of RED 15w in staff member's homes. Our SG230's primary WAN link is a 100Mbit/sec in both…