I have a UTM 9.5 in the cloud. I connect to it with a L2TP over IPsec connection. I establish the connetion and visit some site to check my IP and it shows the IP of my UTM. If I drop the L2TP over IPsec connection and refresh it shows my work IP. So…

I have a physical machine (PM) with physical ports eth0 and eth1. It is running a virtual machine VM0 via KVM. As consequence, eth0 appears aliased to virbr0, such that the only ports that are "up" are eth1 and virbr0. Other VM's lay behind VM0, which…

DMZ, VPN Client, Routing, FW Hello, I would like to setup a router (VPN Client) in a DMZ and route traffic from LAN over DMZ to Open VPN Tunnel. I have the following configuration till now: WAN Interface (Ethernet) : 82.x.x.x LAN: 192…

Hi, I have clients behind a router behind a sophos UTM which I am trying to get internet access but not sure where to go from here. My setup is below: Sophos UTM Connected to Modem (which connects to internet) LAN IP address of 192.168.1.1/30…

I Just hooked up a branch office up via MPLS and I am a bit stumped I have a Laptop plugged in on the Branch office MPLS router, it sees my main office, and vice-versa, but I can't get to the internet from the branch. I added a static Gateway…