How can I find out how many and what are the devices IPs currently connected to LAN
Under Wireless Protection I Can click at Wireless Clients to see what clients are connected to the WiFi.
Can I do the same for LAN devices?
I do have DHCP enabled on the UTM.
Interface communications not working
Hello all... New to Sophos
I'm very excited to have found this free UTM for home use as I simply do not feel I am in control of my home network. I have set up the Sophos on a Dell Optiplex 780 (I think) and added NICs to a total of 6 interfaces.
What…
forbid Access to the Webinterface of the Router for a special VLAN using the SG105
Hi,
in won't allow (forbid) the Access to the Webinterface of the Router for the Guest-VLAN.
But if I block all Traffic on Port 80, no is able to surf in the Internet.
What else should I do?
For good Ideas very thankful.
restrict the Access for multiple Networks over SG105
Hi, Just a “simple” Question, but I only use my Sophos SG 105 at Home, and so I’m no Specialist. I’ve two Networks (192.168.131.0 and 192.168.179.0) on two different Network-Cards (eth1 and eth2). The Access to the WAN on eth0 works for both Networks…
Configuring Vlan beetween Tplink TL-SG108E and Sophos UTM home V9
hi all,
i have a few problems with the configuration of a vlan beetween sophos utm home and the tplink switch.
my sophos has two ethernet interface, one is for ppoe and the other for the local network and the vlan, i set the vlan id at 100 and do…
Open Resolver Check
I've been experiencing Open DNS Resolver attacks and would like to ensure my UTM isn't acting as an open resolver. I've tested through following means
dig +short test.openresolver.com TXT MYIP
Running this from outside the network returns ;; connection…
No internet connecting via ETH0 (WAN interface)
Hello everybody,
my problem is, that i can´t connect to the internet via eth0 (wan interface).
the dhcp and dns server on the utm is also activ and i get an dhcp adress from the utm, but i can´t connect to the internet.
anyone who has the same problem…
Additional Address stops responding
Posting this question again on the new forum.. Here is the link to the old: https://www.astaro.org/gateway-products/network-protection-firewall-nat-qos-ips/59993-additional-address-stops-responding.html
Still battling this problem. Wondering if it is…
add 2 more LAN's to go out firewall and use HTTP/HTTPS web inspection?
Hi,
If I am using 192.168.0.0/24 and I have two neighbors 192.168.61.0/24 and 192.168.62.0/24 are there a LOT of places in the UTM 9.3 product I have to create this network and broadcast and link them to the firewall or web filter rules?
Thanks…