Hey everyone, i have a problem here which turns out to be my final boss. What am I planning to do? I run two Sophos UTM firewalls at home, a UTM 320 which manages the LAN and an SG115 which manages the WLAN. I switched to VLAN operation, before…

Hello, I am going to rent an office space to an external company. I have to separate the network so that the tenant does not reach our internal resources. can i set up vlan to separate? if so, how is this done?

How to separate a Guest Wifi WLAN with a Sophos UTM and a Ubiquity AP with only 1 AP and 1 port on your UTM. My Setup: Cable Modem -> UTM -> Unmanaged switch -> Ubiquity AP Laptops, NAS, Home Alarm are either hardwired to the switch or connect…

Hello! I have a Sophos UTM version 9 (9.707-5), which is setup as a firewall and a VPN server for remote access. On Interfaces & Routing > Interfaces , I have two ethernet interfaces, one "External (WAN)", and one "Internal". Everything has been…

Hello to the one reading, Due to infrastructure changes, I would need to enable LAG on a couple of interfaces. Those interfaces are already configured with Ethernet VLANs and standard ethernet. Can I enable LAG without losing the current configuration…

Dear Sophos specialists, I know your support forum for several years and i always found here solution for my problems. But in this time, after few days of trying, reading topics and thinking i cannot solve current problem on my own. Problem: I have…

Is it possible to have a standard Ethernet interface and a VLAN interface on the the same physical Ethernet port on the SG230 running UTM 9.508-10. The interface started as a standard Ethernet connection on one network and we are needing to expand into…

I'm a newbie to both AstaroUTM and networking both, with some knowledge but limited experience. I would like to learn step by step correctly . I have a LAYER 3 HP Prociurve 3400cl Switch and i would like to use it as CORE SWITCH for my LAB Network.…

Here is our current setup. Sophos UTM at the Gateway. A Dell PowerConnect 2824 managed switch, VMWARE esxi 6.0 running our virtual servers. Our accounting software has been locking up and I was advised by them to add them to their own vlan that network…

Hi folks, there was a question in in the German part of this forum regarding the accessibility between two VLANs, which are configured on the UTM. Therefore I scanned my privat network (VLAN1) from a host (192.168.20.12) in my guest network (VLAN2)…

We recently got our SG230 and now I am stuck with the VLAN configuration. My problem is as follows: We have a default VLAN1 and two additional custom VLANs 2 and 3. Configuration from the switch side: Port01: VLAN1 Untagged Port02: VLAN2 Tagged…

UTM425 All DHCP is coming from the UTM. none use internal DNS, VLAN1 172.17.20.XXX works like it should wifi network for group1 VLAN2 172.17.30.XXX works like it should wifi network for group2 VLAN3 10.0.40.XXX no network access.. gets an IP/DNS…

Greetings Folks, I recently delved into adding two layer-2 switches to my home network getting rid of my un-managed units. I am trying to setup separate VLAN's for private vs guest networks. Can the UTM handle multiple VLAN's on one physical NIC?…