Hello, I am trying to install Sophos V 17.0 on a hyper-V which seems to work however it then asks for a password. Which I don't seem to have. Have tried several default values but can't seem to get in. Would anyone know which password is required…

Hi, We've finished SFOS v17.0.0 GA. We will publish the new release in stages. While we start with a small amount of slots and will increase those over time. Beside that, the release is available to all SFOS version via MySophos portal without staging…

Recently upgraded from 17.0 Beta 2 to 17.0 RC1 and the web exemptions are not working anymore after some time. Reverted back to Beta 1 or Beta 2 until we find out more. Anyone having the same issue with 17.0 RC1 ?

Hey guys, I don't know if the topic is worth a own thread, but is there a special reason why no HTTPS is supported as a web category source? HTTP and FTP are all well and good, but almost every list provider uses HTTPS! And an update interval for the…

Hey guys, i've also just noticed that some entries in the dashboard under "Network Attacks" are shown to me, but the respective reports are empty. I have added an example. Is that the case with me, or does someone else have similar problems? …

Hey guys, since beta 2 I have a sporadic problem with the authentication. After 2 days at the latest I can't log in to the admin interface, user portal or web authentication. The firewall practically freezes. At the admin interface I get an error message…

I installed v17.0.0 Beta-1 onto a Sophos XG105 firewall via USB boot During the install, the firewall did not have internet access, so I skipped registration, the install was completed with the default 172.16.16.16 ip address On finishing the installation…

Hi, there are plans, when xg v17 would be released as final version? How long will it stay in beta state? Regards Meghan

Setup: WAN: public IP Address LAN: private Class C range When creating a DNAT rule and enabling the "Create Reflexive rule" option is selected and a MASQ is required to translate LAN IP range to single Public IP, traffic fails to flow out correctly…

version: (SFOS 17.0.0 Beta-1) When creating a Business Rule DNAT template i have found that, when mixing TCP/UDP/ICMP protocols in the services fieldthe option for re-mapping ports: 1. Remapping option is greyed out and not possible to change the…

I have an XG 135 (original hardware not an SG upgrade) currently running v16.05 MR7, I have uploaded the SF300-32 firmware and it validates fine. When I go to boot to the beta everything appears to be working fine, however, after the reboot it is still…

After an Internet connection goes down and comes back again IPSEC VPN (IKEv1) tunnels are not being automatically re-established. You have to manually re-enable the tunnel within the tunnel status before the tunnel will come back online. I've tested…