Exactly the same question as the thread here RE: Does Sophos support Intel i226-V 2.5G? Except I would like to know then this support will be introduced as these nics have been out forever and linux kernel fully supports now as well.

Hello all. I just received my apparently last NFR License for my XG 210-REV3. It's good until the end of March 2025.How do we go about getting replacement hardware? It's such a shame because this 210 is in MINT condition, and absolutely nothing wrong…

Hi I am planning to migrate my XG-115 to XGS-118 in December 2024. Ability to fully utilise 1000 Mbps fiber internet connection is one of the deciding factors. Does anyone have tried this with XGS-118? If yes, what was the result?

Hi, I am trying to get QAT support information on the current XG Home v21. The last document that mentioned QAT was version 18. Is QAT still supported? If so, what can be offloaded to it?

Good day How do l configure wireless expansion modules on a XGS 136 firewall. Have done all the wireless settings on the firewall

Just for my own curiosity, what is the difference between those two hardware models? Project Z136- 0.07 x64 Project Z136- 0.08 x64 faulty rma The faulty device has no network connectivity on Port 10,11,12

hi i disabled secure boot and then did a fresh install on an nvme drive it stucks on boot "booting 21_0_0_169" any info or help appreciated thanks

Good evening, I got an old Sophos XG86w that is out of support, the status LED often shows an error (red). Otherwise it is running properly so far. This also happens in the BIOS, i.e. OS has not yet started, so the BIOS of the XG86w seems to find an…

Hi, after upgrading several software deployments from SFOS 20.0.0 to 20.0.2 USB Keyboard is not working! - Tested with 2 different Intel Hardware Settings - Tested with Upgrading vom 20.0.0 to 20.0.2 - Tested with new depoyment 20.0.2 - Tested…

Hello everyone! I'm new on this forum and hopefully I can become your friends! [Hopefully] I just getting started for using Sophos firewall with this [Mine was HP T620 Plus] But I will call them "Amaterasu" during deployment. I know the Sophos Firewall…

Hallo Zusammen, ich habe eine Sophos XG135W. Auf dieser läuft XG Home. Nach meinem gestrigen Neustart, starten nun nicht mehr die LAN Ports. Beim starten leuchten diese kurz auf, danach gehen Sie aus und haben auch keine Funktion mehr. Weiß…

So -- in the olden days we could take old retired SG appliances, wipe the drive (delete partitions with Gparted, etc.), and load SFOS Home on them -- we had engineers that would run them at home for training, and to test bleeding-edge releases, etc. Apparently…

Hello, for the connction to my fiberglass provider i need an sfp module with following connection feature: SFP, LC-Simplex, 1000BASE-BX-D, Singlemode. I cannot find one in the compatibility list. Which is compatible? https://www.fs.com/de/products…

Hello, We currently have a XG230 (SFOS 19.0.1 MR-1-Build365) which I was told are no longer supported by March 2025. What will happen if I don't replace it will the firewall stop working?? Thanks for any help

We just purchased a large number of XGS136 and XGS116 firewalls to replace all of our customer's firewalls. We have noticed that all of them are much louder than the previous XG135 and XG115 firewalls. I have see multiple reports of this noise on this…

"After the 20.02 update, all XG 116 firewalls started excessively consuming RAM usage, even in environments with low traffic and queries. I have already opened a ticket with Sophos, but they don't have a solution for this. Is anyone else experiencing…

Hi, I am trying to understand the root cause of my Sophos XG 20.0 MR3 appliance restarting on average of 1-2 times a week. SYMPTOMS : Multiple devices lose connectivity to the gateway (the appliance) at the same time - pings do not respond for about…

Hello I struggle a little bit atm. I had sophos home virtualized on something intel N with 4x2.5G running proxmox. The thing had no legacy BIOS (sadly) so this was my only option. Then I got a SG230 cheap and I installed a intel 10G nic (x520-DA2, 82599ES…

Hi Good Day for all i have issues in my firewall xg125 firmware SFOS 20.0.2.MR-2 Build378 device CPU always is 72% and sometime be 90% and 100% i do everything to solved this problem but still not solved and i following this topic https://support…

Hello, I have Sophos SG 330 Rev. 2, completely new. I have used a USB installer to install the community/free edition of SFOS. The installer went ahead correctly, installing OS on the local SSD, and the appliance rebooted. After I saw that the appliance…

Dear community, I recently purchased a pre-owned XGS116w appliance and would like to run the home license on it. There are several forum posts how to start to get a home license onto a XGS hardware, but I could not find any which actually stated "I…

Hello everyone, I am about to install Sophos Firewall Home Edition v19.5 on the HP T730 ThinClient barebone x86 desktop installed with a 4-port FastLinQ QL41134HLRJ 10Gbe NIC. The NIC sports a Cavium DPDK high-speed packet processing engine. As handling…

Hello. We are using XGS116w right now and wondering which models supporting 10Gbps WAN. I saw that 1U devices have SFP+ modules but inside the SFP+ supported list, there are no tested RJ45 modules that would work for 10Gbps. https://support.sophos…

Hi, Summer time and I need to monitor the Sophos Home firewall mounted on Protectli. In advances shell sensors command doesn’t work and I cannot find any way to monitor it through api or whatever mode. I need to monitor the temperature please could…

Hi, I purchased a used XG 115 Rev. 2 firewall and installed Sophos Home Edition so I can use it as a perimeter firewall at home. My internet connectivity is FTTH 1 Gbps/300 Mbps. If I connect directly to the ISP router by running a speed test I get 900…