I have a Sophos model SFV1C4 with SFOS 19.5.2 MR-2-Build624 After the last firmware my site-to-site connections is timing out. It is Sonicwall that initiate the connections. I am using IKEv2 and after a while I get an error: ID 983 VPN IKEv2 Received…

I am running Sophos XGS 19.5.2 MR-2-Build624 in an active / passive cluster. I have configured IPSec VPN for 150+ remote users. I have approximately 32 split tunnel networks (recently migrated from another vendors platform). I've noticed that once connected…

Hey All, , So i had something interesting that got fixed today. On the old XG V17-19 when you create a IPSEC VPN, you didnt need to add a no NAT rule (I could be mistaken if some one can confirm this) But on the XGS, I had setup all the VPNs…

Hello, We have the following scenario: Two Sophos XG310 with active-passive high availability enabled. Since we configure high availability from time to time, the site-to-site ipsec VPN service just stops working, 80% of our tunnels are disconnected…

Hi, I'm trying to enable an IPSec Site-to-Site connection with a remote location but have a few problems on the route side Here's my config : Sophos XG - SFOS 19.5.2 MR-2-Build624 Sophos LAN on 172.16.16.x (set as LAN in Hosts and services)…

Hi. I am currently working with a test environment and have configured two XG firewalls to have an IPSec Policy-based site-to-site connection between them. I cannot get the IPSec connection to forward traffic correctly. I have been trying for hours…

Ok, i`ve just encountered a strange behaviour/phenomenon with the XGS3100 Firewall we are using: Reacting to a ticket that homeoffice connections via IPsec VPN no longer work, i eventually checked the policy tester to assure myself the FW rules were…

I am having difficulty routing across our vpn's. I need for Host1 and Hostt2 to be able to reach Alert11, Alert12, and Alert13 but currently that isn't happening. I can reach Gateway11, Gateway12 and Gateway13. The network looks like this: NetworkA…

Hi, We are losing our ipsec link after some time. (randomly) Initial connection is ok no problem But in logs we have this message : IPSEC FAILED Couldn't parse IKE message from : X.X.X.X Check the debugs logs ID 18052 If i reinitiate manually…

MO: XGS136/SFOS v19,5,2. Not in production yet, setting up to replace production firewall. BO: XG115/SFOS v19.5.2. In production. MO & BO have had an IPSec S2S running for a long time with the MO production firewall. The MO XGS that will replace…