Firewall VPN site-to-site Sophos GX and Sonicwall - dropping connection
I have a Sophos model SFV1C4 with SFOS 19.5.2 MR-2-Build624
After the last firmware my site-to-site connections is timing out. It is Sonicwall that initiate the connections. I am using IKEv2 and after a while I get an error: ID 983 VPN IKEv2 Received…
IPSEC VPN traffic not passing passing through to DST IP
Hey All, ,
So i had something interesting that got fixed today.
On the old XG V17-19 when you create a IPSEC VPN, you didnt need to add a no NAT rule
(I could be mistaken if some one can confirm this)
But on the XGS, I had setup all the VPNs…
VPN IPSEC Site-to-site service times out in IKE phase until reboot
Hello,
We have the following scenario:
Two Sophos XG310 with active-passive high availability enabled. Since we configure high availability from time to time, the site-to-site ipsec VPN service just stops working, 80% of our tunnels are disconnected…
Can't access or ping IPSec Site-to-Site Local to Remote devices
Hi,
I'm trying to enable an IPSec Site-to-Site connection with a remote location but have a few problems on the route side
Here's my config :
Sophos XG - SFOS 19.5.2 MR-2-Build624
Sophos LAN on 172.16.16.x (set as LAN in Hosts and services)…
Site-to-Site IPSec Not Working As Intended
Hi.
I am currently working with a test environment and have configured two XG firewalls to have an IPSec Policy-based site-to-site connection between them. I cannot get the IPSec connection to forward traffic correctly. I have been trying for hours…
IPsec traffic no longer in VPN Zone?
Ok, i`ve just encountered a strange behaviour/phenomenon with the XGS3100 Firewall we are using:
Reacting to a ticket that homeoffice connections via IPsec VPN no longer work, i eventually checked the policy tester to assure myself the FW rules were…
XG v19.5.2 ipsec VPN routing problems
I am having difficulty routing across our vpn's. I need for Host1 and Hostt2 to be able to reach Alert11, Alert12, and Alert13 but currently that isn't happening. I can reach Gateway11, Gateway12 and Gateway13. The network looks like this:
NetworkA…
XG 210 IPSEC DOWN FAILED PARSING IKE
Hi,
We are losing our ipsec link after some time. (randomly)
Initial connection is ok no problem
But in logs we have this message : IPSEC FAILED Couldn't parse IKE message from : X.X.X.X Check the debugs logs ID 18052
If i reinitiate manually…
New S2S can't connect
MO: XGS136/SFOS v19,5,2. Not in production yet, setting up to replace production firewall.
BO: XG115/SFOS v19.5.2. In production.
MO & BO have had an IPSec S2S running for a long time with the MO production firewall.
The MO XGS that will replace…