• Sophos Connect - slow and freezing connections for SMB and RDP

    lukg
    lukg
    I'm using Sophos XG 4500 v19 and we have noticed that connections to SMB servers when using Sophos connect remote access with default IPSEC profile are slow and unresponsive. DoS protection is off and we are not using traffic shaping. Any Ideas…
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • XG 19 SD WAN Application timeout

    Geniux
    Geniux
    I have XG V19 Firewalls and created a SD-WAN policy to handle traffic for Site 2 Site Route based IPSec VPN with xfrm interfaces. it works great, just some strange issue, many application that are used over that VPN timeout and crash after around 15…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Sophos Upgrade auf (SFOS 19.0.0 GA-Build317), seitdem kommen Zertifikatsmeldungen bei Outlook!

    Andreas Wuschansky
    Andreas Wuschansky
    Hallo zusammen, gestern habe ich das Upgrade von SFOS 18.5.2 -> SFOS 19.0.0 GA-Build317 durchgeführt. Seitdem kommen bei Outlook (2019) immer die Zertifikatsmeldungen bei erstmaligem Abfragen der E-Mail Konten (IMAP+POP) Ich habe geschaut, das SSL…
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Problem with WebAuthentication after Update to V19

    Stiftung Eben-Ezer
    Stiftung Eben-Ezer
    Good morning, we have a problem with WebAuthentication from Sophos FW which is not actually enabled, in V18.5.3 no one had to log in to access the internet and now many users get a prompt to log in to use internet. We use STAS and SATC for synchronizing…
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Delayed Printing / Invalid Traffic

    FFin
    FFin
    I'm not sure we might face a similar problem to https://community.sophos.com/sophos-xg-firewall/f/discussions/131346/sophos-xg-firewalls-printer-delay-or-not-printing-at-all We implemented a new Sophos XGS 3100 running SFOS V19. Basic firewall-rules…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • SOPHOS XG230 wont connect to the internet after update

    Takudzwa Vunganayi
    Takudzwa Vunganayi
    Hi i have a firewall that updated from 18.0 to 19.0 the we startedfacing network challenges some users are connecting, some cant connect. If we roll back users can connect but now if we roll back users cant connect to the internet
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Since the update to XG330 (SFOS 19.0.0 GA-Build317) the VOIP software no longer works over the VPN

    Shawn Adams
    Shawn Adams
    We use MiVoice 2380 Softphone here at work, I went from SFOS 18.5.3 MR-3-Build408 to SFOS 19.0.0 GA-Build317 and this is the only issue we are now having. The Software works just fine in the LAN including calling to the WAN however from the WAN to the…
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Safe to upgrade XG210 (SFOS 18.5.3 MR-3-Build408) in HA to SFOS 19.0.0 GA-Build317?

    Fred_B
    Fred_B
    In the thread "SFOS 19.0 almost bricked my XG230" a general conclusion is " Looks like there is some compatibility issue of the latest SFOS 19.0 with XG2XX series hardware " Is this the case? TIA, Fred
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Sophos XG API / Lets Encrypt / PowerShell 7 / WAF Update

    nplm85
    nplm85
    Hopefully this can help others. I'm running the home licensed version and just recently moved to v19 I have a few WAF's that are configured externally this script is to do the following. Renew Multiple certificates that are already configured…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Simple firewall rules doesn't trigger

    TheBard
    TheBard
    I've recently updated to latest version (19), not sure if it's related. I've added a simple rule to allow ssh between two machines in different vlans, but didn't work. I tried stripping down some restriction to Any-Any between the whole subnets and…
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • VPN ne fonctionne plus en V19

    CyrilleM
    CyrilleM
    Bonjour Sur un XG230, la mise à jour 18.5MR3 vers 19.0GA a été proposée dans la mise à jour de firmware. J'utilise plus de 50 clients en connexion VPN SSL Aucun soucis en version 18.5 MR3. Je ping bien IP serveur de destination, aussi bien par…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Exchange / WAF - OWA, ActiveSync 1MB File Limit - SFOS 19 GA

    FFin
    FFin
    I'm getting following error in WAF-log: ModSecurity: Request body no files data length is larger than the configured limit (1048576) Is there a new switch in gui or command line to increase 1 MB limit in V19? There were forum posts some years and…
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Owned SSL Cert not working in captive portal SFOS 19.0.0 GA-Build31

    Andrew Laing
    Andrew Laing
    Captive portal in version SFOS 19.0.0 GA-Build31 is not using specified certificate as admin portal. Captive portal is using SOPHOS cert which is not correct in my setup. See below images. Have tried fresh re-install, upgrade removing and re-adding…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • XG135 - SFOS 19.0GA-317 ignored firewall/NAT rules and policies

    lu_ne
    lu_ne
    After updating from SFOS 18.5.3 MR-3-Build408 to SFOS 19.0.0 GA-Build317 I started getting complaints of services not working, they depend either on outbound firewall rules or inbound DNAT rules. The first failure to be reported was VoIP, oddly enough…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • SSl Vpn

    Brij Kishore
    Brij Kishore
    SSL VPN does find host after update to SOPHOS 19.0.0
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • V19 - Some websites no longer work via VPN

    M8ey
    M8ey
    Hey guys I have a very odd issue. Loaded V19 last night to my XG450 - all loaded fine and seems OK today - until the Remote users started raising tickets that some sites wouldn't load. I cant work out why... - They loaded before V19 - the…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • SFOS 19.0 almost bricked my XG230

    webmaster webmaster
    webmaster webmaster
    Hi, did a standard FW upgrade today during lunch....big mistake. The XG booted into failsafe mode and stayed there. The garner service did not manage to start. Did a factory reset, then loaded the configuration. Same thing. After a bit of plundering…
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • V19 & Custom policy support for IPSEC Remote Access

    Ant-P
    Ant-P
    We're currently on v18.5.3 and have approx 70 users with IPSEC Remote Access. One of the big improvements for us in v19 is the Custom IPSEC RA policy, and the adjustment of re-key times. After we upgrade to v19; Will all current IPSEC Remote Access…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Azure Site to Site IPSEC VPN slow

    Stefan Jansson
    Stefan Jansson
    Hello We ourselves have an XGS2100 in the office and an XG in Azure. Tunnel is up (IPSEC) and we can ping and connect with RDP to a server (Windows 2022) in Azure. But when we access files on a file share on a server in Azure, we get a speed of about…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • IPSEC Remote Access .scx file invalid

    Craig Glaser
    Craig Glaser
    I'm trying to configure an IPSEC remote access VPN. When I download and extract the configuration archive, the .tgb file appear to be valid, but the .sck file only contains the following: cannot open file /tmp/root_cert.txt at /scripts/vpn/ipsec/generateJSONVPNClientConf…
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Exchange Server Over VPN

    Usman Afzal
    Usman Afzal
    Dears, After doing the update to Version 19, we are now experiencing a peculiar problem. Every intranet is operating normally, and branch offices are linked to the main network through site-to-site VPN. at the same time, We are using a locally hosted…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Saturated Bandwidth Sophos XG

    David Moro
    David Moro
    Hi guys, 1 of my customers has a brand new XGS2100 with v19.... when i try to take a speedtest from a pc... all the other pcs goes offline... even my teamviewer goes off... and when the pc finish the speedtest all bacame back online... Even if i…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • V19 fails 1 time per day on Hyper-V

    Hermann Floimayr1
    Hermann Floimayr1
    SOPHOS is running on Hyper-V 2022. SFVUNL (SFOS 19.0.0 GA-Build317) About 1 time every day the SOPHOS VM freeze. This is the Error: - < Event xmlns =" schemas.microsoft.com/.../event " > - < System > < Provider Name =" Microsoft…
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • Alert emails being sent repeatedly after SFOS v19 was made available for installation

    Jon Beets
    Jon Beets
    Since SFOS v19 GA was made available for download, my XG115 has been sending me alert emails, despite checking the 'Do not notify' option on the popup. I have SFOS 18.5.3 MR3-Build408 available however v19 GA is no longer shown. Is there somewhere where…
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • PPoE Wan connection drops over and over

    oner sezgin
    oner sezgin
    We are using xg115w v19 Wan connection drops and connect again around every 20-30 minutes and Why I can not save override mss section? thanks
    • Answered
    • over 2 years ago
    • Sophos Firewall
    • Discussions
  • View related content throughout Sophos Firewall
  • More
  • Cancel
<>