Hi, I moved to Version 21.0 GA (Home Edition) recently. I noticed that in control panel, no events in the log or counters are logged that X-Ops is doing anything: A configured third party threat list (abuseipdb.com) is working properly and blocks…

Hi all, im pretty new to the sophos firewall i noted that on the dashboard it showed an attack and also checked the logs whcih are both shown below. From this i can see that it was detected rather than blocked. Is there a way to set the IPS to block by…

Hi There I recently acquired a second-hand XG115W. After wiping the SSD, I successfully installed the V20 HOME firmware on it. However, I've encountered this issue after the installation: Ethernet ports 2 and 3 do not function. I can see the activate…

Hi Sophos Community After a lot of trial and error I'm hoping you can help me finding a solution to my scenario: In my home setup I have my wan-interface of the sophos in a transit network. My ISP router forwards any traffic to the sophos. Now…

.Hello @all! So I have asked in the past a few questions about QoS, but I had a more complicated setup with two WANs and additionally the second was a bonding between an ADSL line and a 4G+ sim card, which was nor really steady regarding the bandwidth…

Hello!! In my home network, I have a mini PC with two ports running Proxmox and a virtualized Sophos Firewall Home Edition. I have purchased a mini PC with four ports to replace the one I currently have. While I wait for it to arrive, I decided to…

Hello everyone, I’ve included my home network diagram and Sophos configuration below. After setting up Sophos Home (on ESXi) in bridge mode with VLANs, I assigned a static IP address of 192.168.11.10 to the bridge port. However, this IP address cannot…

Hello Everyone, I am a new user of Sophos Firewall for Home, unfortunately I am encountering a few issues. I have managed to get an internet connection on it but I am unable to register it and getting the following error - Can't connect to the registration…

Dear community, As a firewall noob I am wondering how to integrate a dynamically changing list of IPs into an allowlist for a specific firewall rule. As a home user I unfortunately have no access to the "Web protection subscription", only "Base Firewall…

Hello All, I am a newbee to XG, but have been using UTM9 for some years. In UTM9, I could see a number of attacks being dropped every day. After I changed to XG (version SFVH [SFOS 20.0.0 GA-Build222]) I do no longer see any attacks. I have activated…

Hi, I have been given an iptables command and I would like to create the same rule on my XG. Could anyone confirm if I have "translated" the rule correctly, please? iptables -t nat -I PREROUTING -s 10.100.20.19 -d www.riscocloud.com -p tcp --dport…

Hello, When I configure the bgp on sophos XG home I enter a network for advertise. Is it a way to advertise automatically new network or I must enter info manualy each time? regards

Hi, I am wanting to block the IOT network (xxx.xxx.5.xx/24) from pinging the default gateway of other networks so created a firewall rule to do so however when testing, devices in the IOT network are still able to ping the default gateway of other networks…

Hello, Today I found a case that I've intermittently found in the past, but I decide to bring it up in the forum and try to find a permanent solution. I connected to a public WiFi network with an iPad. The network provided the following through…

Does anyone experienced the same thing? Messenger app chats with End to End Encryption enabled cannot send messages behind Sophos XG Firewall. There's also a lot of ISAKMP VPN hits in the traffic insights recently. I'm also thinking my XG instance is…

Hello everyone, Today I am trying to deploy a network system running load balancing But I am currently stuck with a problem. That is, I cannot get the VLAN to use the correct internet line that I want. My idea: i want VLAN 50 and VLAN 70 to…

Hello everyone. I am running Sophos Firewall SFVH (SFOS 19.5.3 MR-3-Build652) I have a primary fiber internet connection and a 4G connection as a backup gateway. This is set to enable when the primary connection fails. I want to disallow Internet…

Hi, I have gone through a fair bit of posts and how-to online, so I decided to post the question here, after 5 days researching this. ---------------------- My setup: Motherboard with 1 built-in 1000mb/s ethernet port, 2x PCI-e cards HP NIC 2 ports…

I have got 2 Sophos FW Home firewalls (Home, and In-laws) running V20.0.0 with a red-link working between them. This link has historically been Static Routes at each end and has worked perfectly but we want to separate some traffic so I have tried to…

Hello, My GPON ONT converter device is one without the DHCP mode (static IP 192.168.50.x). Once I have connected my Sophos XG firewall device with it for a successful PPPoE dial-up, I can no longer access it by assigning a static IP of 192.168.50.y…

Hi everyone, I set my Firewall Wan Port to 1000 mbps Full-Duplex with Auto-negotiated enabled. I thought the solution was to set the WAN bandwidth to 1000 Half-Duplex but there is no option (only 10 HD, 10FD, 100 HD, 100 FD and 1000 FD) My Modem (Vodafone…

Hello all, I have a specific NAT question and problem, the reason would be, that am not a native or excellent networking guy... so learning by doing and reading specific when needed. Maybe someone could help me. In my home network I use a XG as…

I've created a firewall rule & NAT rule to forward port 5555 to my local server ssh server and it was working perfectly -for sometime- but it keeps failing now and i can't access, after scanning port it keeps saying that it's closed? I recreated the…

Hey, I have Sophos Firewall for Home installed on my proxmox. I have a 500Mb/s download and 100Mb/s upload connection. Unfortunately when downloading anything from the internet the maximum speed I can download at is 20MB/s it gets to that 20 and is unable…

Hi All, I would like to connect my Unifi Dream Machina Pro (UDMP) router to Sophos XG Home (SFOS 19.5.3 MR-3) installed on a separate computer with two LAN ports. What I want to do is not obvious and I don't know if it's even possible. In general, the…